use enough but not too much
The ions should form CaCl2 because the two chlorine atoms each take an electron from calcium to form the chloride ion Cl-, and the calcium becomes Ca2+ ion.
No, they simply form a solution of calcium chloride. This is correct, but one should add that the solution heats up because of the exothermic process involved when water causes the calcium chloride crystals to dissolve; the calcium chloride is dissociated into calcium and chloride ions. However, the question is why does the solution test as an acid when phenol red is added? The red solution turns yellow indicating an excess of hydrogen (hydronium) ions. There is no adequate answer that I could find on the Internet.
Manufacturers may use powdered calcium carbonate as a source of calcium in the production of calcium chloride due to its high calcium content and cost-effectiveness. Powdered calcium carbonate can also be easily mixed with other ingredients during the manufacturing process to produce calcium chloride products with desired characteristics and performance.
Salt is made up of calcium and chloride. Calcium is a necessary ingredient to a good diet.
Rock salt (or calcium chloride, potassium chloride) is applied to roads with ice or snow; the freezing point of water is lowered.
It is unlikely that calcium chloride crystals are made from calcium metal because calcium is a rare and very expensive metal, also very susceptible of corrosion in normal air.It is much easier to start with limestone (CaCO3) and dissolve it with hydrochloric acid. Carbon dioxide is released and the excess of water should be evaporated after filtering of the undissolved particles of the limestone impurities.(CaCO3)s + (impurities of limestone)s + (HCl)l => (CaCl2)s + (CO2)g + (H2O)evap ++ [impurities of limestone]filter
My guess is that it would not "fizz" at all.The Fizz that one often sees when mixing calcium carbonate, sodium bicarbonate, etc with an acid is the releasing carbon dioxide CO2 from the Carbonate ion CO32-.Calcium Chloride is a salt. It will likely dissociate in the solution, but I doubt it will "fizz".If you mix Hydrochloric Acid with Calcium Carbonate you get:2HCl + CaCO3 --> CaCl2 + H2CO3 --> CaCl2 + H2O + CO2Where the Calcium Chloride is more likely kept in solution as Ca2+ + 2Cl-
This word equation is incorrect because it does not follow the law of conservation of mass. The equation should be: calcium chloride plus magnesium sulfate yields barium sulfate plus magnesium chloride.
Pickles should not be only used on sandwiches.
If it's not a prescription, then there should be some thing on the package that says if it contains any wheat or gluten.
1 L of water weights 1000 grams: Suppose you need X grams of calcium chloride.X grams CaCl2 / [X + 1000] grams solution = 0.35 = (35%/100%) and than solve the XX = 0.35 * (X + 1000)= 0.35X + 350X - 0.35X = 3500.65X = 350X = 350 / 0.65 = 538.46 = 538 grams of calcium chlorideAdd 538 grams of calcium chloride to 1 Litre waterand you'll getabout 1.54 kg of the 35% CaCl2 solution (this is less than 1.54 Liter!!)
Sodium, Na. Potassium, K. Calcium, Ca. Magnesium, Mg. Chlorine, Cl. Bicarbonate should be CO2. Phosphorus, P.