answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: How do you take the top off a roper washer?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about General Arts & Entertainment
Related questions

How do you take a Gyro off?

After you disconnect all of the cables, you have to remove the handlebar stem (loosen stem bolt half way, then knock the wedge loose by hitting the top of the bolt), remove the top part of the Gyro, then take off the top nut of the headset. Instead of a washer, you'll have the bottom part of the Gyro. You MUST replace the part of the Gyro that's under the headset nut with a headset washer or you'll never be able to keep your headset tight.


Turned water off now no supply to upstairs toilet?

Shut the water off, at the toilet if possible, take the line loose that goes to the tank and see if it is the supply line or the filler valve. I'll bet it's the valve. If you have the type that has a round float that rides up and down on a post, they have a washer in the top with a small hole in it that lets the water in. Rust and corroisen can break off when you shut the water off and it will plug this hole. Hold the shaft so that it doesn't break and twist the top 1/8 turn counter clockwise. The washer is in the top of the stack, black about the size of a quarter. Take the washer out and turn the water on slightly to push out any particles that might block the hole in the center of the washer. Reassemble and I bet it works.


How do you fix water faucet when you turn it on and the water stops its only the cold water?

If the handle make a complete or almost a complete turn, it has a washer that makes the seal to stop the water. This washer will sometimes come apart or come off the stem and get stuck in the opening for the water. Take the stem out and replace it. Shut the water off, there is probably a shut off under the sink, take the handle off. It is most likely held on with a screw in the top. The stem is held in with a nut. Take the nut off and the handle unscrews out of the faucdt. The washer is on the bottom of the stem and held on witha small brass screw.


If replacing an alternator in 1997 Lincoln Continental how do you get it out?

You have to unbolt the cross brace from the radiator support,the windshield washer tank and the over flow tank,then you can work it down and out. I just changed mine and all you have to do is take your overflow tank off and move your power stering res out of the way. take the bracket off the top of the alternator then take the belt off remove the 4 bolts on top and the 2 on bottom then slide it out. you do not have to take the cross brace off or the winshild tank off.


You just fix the flapper now there no water in tank why?

You shut the water off and the fill valve is the type that is in the corner of the tank and the float rides up and down on a shaft? If so, a piece of rust or mineral is plugging the valve. Shut the water off, hold the shaft of the fill valve and twist the top 1/8 turn counter clockwise. The top will come off and where it separates, there is a black washer with a small rod in the center of it. Take the washer out and slightly turn on the water. This will flush out any particles in the line. Shut the water off, replace the washer and put the top back on. This should fix the problem.


What's the difference between a front load washer and a normal washer?

The difference between a front load washer and regular washer is that a front load washer has a door in front were clothes are loaded and that is also where washer settings are located. The regular washer is usually a top load where clothes are loaded on top of the washer.


Is it scary getting fitted for a bra Do you have to take off your top?

yea they take your top off i remember when i got fitted it was scary..


How do you fix dripping faucet?

Switch off supply, unscrew top pf faucet, remove stem and washer (or cartridge) take it to store, buy identical one, come home and re-fit in reverse order.


How do you take the top off a 1991 Jeep Wrangler?

A hard top or soft top?


What exact is stack able washer dryer?

Instead of the washer and dryer being side by side, the dryer is stacked on top of the washer.


What is the difference between a front loader and a top loader washer?

The difference between a front loader and a top loader washer is that one has a door on the barrel. This type of washer can be seen in most laundromats that handle large loads of clothes This is general an easier washer for people with mobility issues and it uses less water. The door opens like a front door to a house or a car door. The top load washer has its door on the top of the washer and clothes are put down into the opening. The top load washer can be more difficult for people with mobility issues. This type of machine usually uses more water.


How do you get you boyfriend attention?

Take your top off.