answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: In VFD start why output is derated?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How Elevation effect in mechanical engineering?

EQUIPMENT OUTPUT DERATION: Particular example is the Generator Set installed at 1000 meters above sea level the power output is derated due to pressure.


What are the benefits to get three phase output from single phase input by vfd?

The only benefit is you don't have to pay for a three phase service for just one motor.


Speed control of three phase induction motor by supply voltage control using AC voltage regulators?

No. Use standard utility AC, 3 PH voltage to feed a Variable Frequency Drive (VFD). The VFD is then wired to the motor. The output of the VFD varies average voltage and frequency in a semi-constant proportion to keep Volts/Hertz ratio the same to the motor. The operator can then adjust or select the desired speed from the VFD and the VFD will run the motor continuosly at that desired speed. If you were to control only voltage to the motor without adjusting frequency in proportion, the motor would burn up.


What is a VFD and can it be connected in single phase to obtain three phase power?

Depending on the amount of money you want to spend to make this happen there is a device on the market called a VFD ( Variable Frequency Drive). On the three phase input terminals you apply your single phase voltage. On the output terminals you connect your three phase load. When run in this configuration there is an internal switch that has to be changed to let the VFD know that it should be looking for only two lines on the input to be hot. Other wise the VFD thinks that there is a line loss on the three phase input


Did VFD exist?

Yes because VFD means Volunteer Fire Department and there are many characters in it


How do you install a timer to a VFD?

You can either use the inbuild timer in VFD or go with secondary timer or a controller like PLC. You may use the below link to learn more on VFD www-dot-smeclabs-dot-com


What to do to reduce the noise generated because of VFD or Motor?

To reduce the noise generated because of VFD harmonics, line filters have to be used on the line side and load side of the VFD. The specific filters suppress the harmonic frequencies that the VFD generates when the SCR's are rapidly turning off and on.


Is vfd real?

Yes


What brands of VFD's are you familiar with?

NO


How does the output voltage of the VFD change if the DC bus voltage level is fixed?

The VFD outputs pulses at the DC bus voltage. Each pulse is from the DC bus and the voltage does not change. It is the average voltage that changes because the VFD changes the on and off times of these pulses. For a lower average ac voltage to the motor, the ON time is small and the OFF time is large. The VFD actually pulses about 4000 times per second, so the motor does not really know these are just lots of quick DC bus voltage pulses. To simulate an ac waveform, the VFD uses pulse-width modulation which means the pulse ON time at the peak of the simulated sinewave is longer, or fatter, than the pulses where the simulated sinewave is closer to 0 crossing.


Is count olaf in vfd?

Yes, he is.


How did the Lakota treat strangers?

vfd