0
Is a Model 610 with a fluted cylinder 5 inch barrel Smith and Wesson 10 mm an unusual combination?
Wiki User
∙ 14y ago
S&W made the model 610 for only a few years so there aren't going to be a lot of these to compare to. On the other hand, if someone is looking for one, they're not going to have a lot to choose from. The 5" barrel does make this gun more desirable.
The unfluted cylinder is kind of a "style" thing (although fluting was originally introduced every early on in order to assist with the cooling off of the gun after firing). S&W introduced a number of unfluted-cylinder models in various calibers as part of their "Classic Hunter" line although most of those guns (including some 610s) had 6-1/2" barrels.
If you want to learn more about this gun I recommend you open the cylinder and look in the crane. You might see either 610 (by itself) or 610-1 or 610-2. These "dashes" designate some engineering changes that occured. They will make very little difference in the gun's functionality but will mean a great deal to a collector/buyer.
Generally, also, the older the better. So if their condition is equal, a 610-1 might be worth more than a 610-2. And the 610-no-dash is probably the most desirable of any.
If you're interested in such things, I strongly recommend you purchase Supica & Nahas' Standard Catalog of Smith and Wesson. It's a tremendous reference source on the history of models, some approx values (which can vary widely) and in tracking down the age of a particular gun.
Good luck.
I just bought a 610-3 with a 4" barrel. Not the most popular or common S&W since most people don't want an auto caliber in a revolver, and fewer yet want a 10mm. Ammo is scarce and expensive. As a reloader I welcome the caliber and enjoy it.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
What is the value of smith and Wesson handgun K 349007 also is marked HRR long rifle CTG on barrel . Definitely Smith and Wesson.?
Made 1961. Value 0-1000 USD depending on exactly what you have, the configuration it is in, if it is factory original, overall condtion, if the box and papers are present, etc..
What is the value of a smith and Wesson 624?
The gun lists at about $525 and can be found new for about $400. Depending on condition, used should start at about $350 and go down for increasing wear.
What is the age and value of a 38 caliber Smith and Wesson model10 serial number C481678?
That depends on the condition of the gun, what type of barrel and the lengnth. What grips and type of finish it has and if it was abused or not. Lets not forget the inside condition of the gun, bore, cylinder lock up, end shake. A really good S&W M10 with heavy bbl, blue finish, original wood Magna Stocks around $250.00 to $350.00. Now with original box and paper work a little more, say $400.00, $425.00.
Disassembley for smith and Wesson 909?
Make sure the weapon is unloaded, remove the magazine and then make sure the safety is in the off position. Pull the slide to the rear about 1 inch until the slide stop is below the notch in the slide. Hold the slide in that position and push the slide stop pin from right to left and remove the pin. Let the slide move forward and off the frame. At this point, you have access to the recoil spring and barrel. You can remove the recoil spring, guide rod and barrel at this point.
What rhymes with Cheryl?
Christmas carol. or maybe even barrel. Carol Apparel, barrel, peril, ferrel, sterile, beryl, feral,
What is the value of a 38 sw special ctg stamped on right side of barrel 6-cylinder revolver no patent date left side of barrel smith and Wesson?
Age of smith Wesson serial no 5K4166
What date was smith and Wesson 861885 manufactured what is the model?
model stamped inside cylinder housing near barrel.
Where is the model number of a Smith and Wesson 357 mag snub 2 in stainless barrel?
Look on frame inside the cylinder area to find the model number of a Smith and Wesson 357 mag snub 2 in stainless barrel
What is louder 380 pistol or 38 special smith and Wesson?
A revolver is louder than a pistol due to the barrel-cylinder gap that is located between the cylinder face and forcing cone of a revolver.
How old is your Smith and Wesson Air weight with 2inch barrel and blue finish and 6 shot cylinder serial?
No serial number provided; no way to answer.
What model is the Smith and Wesson pistol weapon serial number 152816?
look inside cylinder well for model near rear of barrel in frame
What is the name of the part that spins the barrel in a smith and Wesson revolver?
the barrel does not spin in a S&W, or any other brand of modern revolver. The part that rotates is called a cylinder, and it is turned by a piece that is called a "hand ", or a "pawl".
Where can you get a barrel for your Smith and Wesson model 1000 barrel?
Try e-gunparts.com
Smith and Wesson barrel interchangeable 581?
No
What is the value of a Smith and Wesson model 19-3 serial 7K27659?
Your Smith and Wesson model 19-3 which dates to the year 1975 will bring between 300-550 dollars depending on overall condition of the revolver,to include the amount of original blueing remaining on the barrel frame and cylinder,and the grips condition,and the barrel condition.
What is a cylinder bored shotgun barrel?
A shotgun barrel with a cylinder bore choke.
Age and value of smith Wesson 38 special ctg model 86588 c above 5 7 above 8 6 cylinder 6 in barrel smith Wesson marked on one side of barrel 38 sw special ctg other side pat 367208 4152024 like new?
1965 approx
