Lead in stern tube oil analysis typically indicates wear or degradation of components within the stern tube assembly, particularly the bearings or sealing surfaces. Elevated lead levels may suggest that lead-based materials are being worn down, potentially leading to increased friction and eventual failure if not addressed. Regular monitoring of stern tube oil for lead content helps in assessing the health of the propulsion system and preventing costly repairs or operational disruptions.
Oil lubricated and sea water lubricated stern tube
I heard on you tube it was his real life girlfriend???
The dead time of a Geiger-Müller tube refers to the brief period immediately following the detection of a radiation event during which the tube is unable to register another event. This occurs because the ionization process and subsequent recovery of the tube's sensitive gas takes time, during which any incoming radiation will not be detected. Dead time is crucial in determining the tube's counting efficiency and overall performance, especially in high-radiation environments where events can occur in quick succession.
A Miller-Abbott tube is a tube used to treat obstructions in the small intestine through intubation.
There is no tube on Lego Harry Potter.
Oil lubricated and sea water lubricated stern tube
A royal blue or lavender tube is typically used for lead blood tests. These tubes contain an additive that helps preserve the stability of lead in the sample during transportation and analysis.
a big ship
a big ship
The stern tube in marine engineering allows the propellor shaft to penetrate the hull of a ship and prevent the ingress of water. It also acts as a bearing and lubricates that part of the shaft.
Lavender/purple-topped tube is typically used for collecting synovial fluid for analysis.
The propeller shaft in a boat engine is fastened to the flywheel by bolts, and it passes through the boat's thrust block and is aligned with the shaft tunnel. It also passes through the stern tube to drive the propeller. The stern tube shaft itself holds the "prop" shaft in place and shut off the open end when it pierces the aft hull. It is commonly manufactured as cast iron and welded into the frame of the stern of the ship.
A lavender top tube is typically used to collect blood samples for homocysteine level analysis.
It is a tunnel-like opening at the vessel's stern, through which the propeller or tail shaft passes, in order to connect the propeller to the engine.
it houses stern tube,give strength to aft portion,give profile to aft deep tank,support stringing member
Lead levels are typically drawn in a lavender-top tube that contains EDTA as an anticoagulant. This tube is used to prevent clotting and maintain sample integrity for accurate lead level measurements.
If you mean in the uterus nothing happens. But if you mean in the right fallopian tube it's a ectopic pregnancy and it has to be aborted or the fallopian tube will burst which will in the end lead to the woman dying.