Older style light bulbs got very hot so they needed to be made of a substance that could withstand high temperatures and also allow light to pass through. Glass fitted the bill on both counts, plus it was cheap to produce and can easily be made into the required shapes.
-It's a very old technology quickly being replaced by newer more efficient technologies. -The light produced in the bulb is created by electricity heating up a filament inside the bulb creating light. This wouldn't be possible without the bulb however, since oxygen would quickly end this reaction of the filament through oxidation.
There is a small chance that if you splatter something it will get in the light bulb terminal and make it rust or cause the light to shut off or burn out. It isn't going to hurt the microwave if you don't have the cover on though.
paint a light bulb green, or alternatively, pop into B&Q and buy a green light bulb, eco friendly or filament, it's up to you, but i suggest eco friendly, get it? with the whole "green" situation
Thomas Edison did not invent the light bulb, but he improved upon existing designs to create a practical and commercially viable version. He was 30 years old when he patented his version of the incandescent light bulb in 1879. Edison's work significantly advanced electric lighting technology, leading to widespread adoption.
Yes it is possible to make an acid battery using the acid in a lemon. (you would need allot of lemon batteries to light a flashlight bulb though - try using a diode light bulb) For more information on how to do this look in the link I will place below.
It is called metal,plastic or steel so copper is also magnetic which alows the copper to make the bulb be brighter and to light up thankk you for listening...
The citric acid inside in a fruit could make it work. Fruits that is part of the citrus family has a contains a citric acid. For example a lemon, it could make a light bulb work. :)
I'm not sure of the make of your vehicle but normally the plastic lens cover will pop off. If you get the cover off the bulb usually pops out. Do not use pliers as the bulb could shatter and get glass all over. (EYES) If you get the bulb out, before you put in a new one, close the car doors and make sure that the dome light is off. They get real hot real quick.
Gently grasp edge of plastic light diffuser with your finger nails and pull down releasing plastic hook/thorns. If bulb still works, make sure light has been off for several minutes to prevent burn injury. Push contact apart releasing bulb and replace with bulb 6411(festoon type).
A light bulb can make heat and light.
Make a circuit with 2 wires a batery and a light bulb and touch wire to medle on light bulb
locate the main wire and make some pressure at the plastic housing in the rear bumper and pull backward, now remove it from the bumper. after that make a half turn to the plastic housing where the light bulb is located. now you can remove the light bulb form housing, replace for a new one . repeat the step by step to place the housing bulb on the bumper and ready to roll.
Electricity + Glass = Light bulb
argon is an element that make up a light bulb
a regular light bulb-no.
Yes, we could still live without the light bulb as there are alternative sources of light such as candles, oil lamps, and natural daylight. The light bulb has made life more convenient and efficient, but it is not a necessity for survival.
argon is an element that make up a light bulb