0
Explain how to flush impurities from a water regulating valve that is on a water cooled condenser?
To flush impurities from a water regulating valve on a water-cooled condenser, first, isolate the valve from the water source by closing the necessary isolation valves. Next, open the drain valve located downstream of the regulating valve to allow the impurities to be flushed out. It is important to flush the system with clean water to ensure all impurities are removed. Finally, close the drain valve and reopen the isolation valves to resume normal operation.
What else can I help you with?
What is the principle of fresh water generator?
The principle of a fresh water generator involves the distillation process, where seawater is heated to produce steam, which is then condensed to yield fresh water. This process typically utilizes waste heat from engines or boilers to evaporate the seawater, separating salt and impurities. The resulting steam is cooled in a condenser, leading to the formation of distilled water, which is collected for use. This method is efficient and widely employed in marine applications and arid regions for freshwater production.
Why must helium be cooled to 4k before it will condense explain the fundamental process?
The single atoms of helium gas are small, and has small surface area. They must be cooled to 4K before their attractive forces cause them to condense.
What substance would gas change into if it was cooled?
a liquid then if cooled further it would turn into a solid a liquid then if cooled further it would turn into a solid
Which freeze faster salt water or tap water?
Put both in the freezer and use a timer. It must be in a freezer, because if you have ever heard of super-cooled water, a lack of vibrations causes water to remain liquid below the normal freezing point (0 degrees Celsius), that is if it is not disturbed at all.
As water is cooled its density does what until it reaches about 4 C?
As water is cooled its density increases until it reaches about 4 C and then it decreases.
When water-cooled condenser cycles off the regulating valve should?
When a system with a water-cooled condenser cycles off, the water regulating valve should
When water cooled condenser cycles off the regulating valve should?
When a system with a water-cooled condenser cycles off, the water regulating valve should
What are the symptoms of an cooled Condenser when the air leaving the condenser is hitting a barrier and recirculating?
What are the symptoms of an cooled Condenser when the air leaving the condenser is hitting a barrier and recirculating?
What TD is used to determine the condenser performance of a water cooled condenser?
The approach temperature difference (ATD) is used to determine the condenser performance of a water-cooled condenser. It is the temperature difference between the refrigerant condensing temperature and the cooling water inlet temperature. A lower ATD indicates better performance and efficiency of the condenser.
What is main the function of condenser?
heat rejection through converctional or static means.(fan or air cooled condenser)
What is one main function of the condenser?
heat rejection through converctional or static means.(fan or air cooled condenser)
What is the cause a dirty air cooled condenser?
Excessive head pressure.
What two places heat can be deposited in in a water-cooled condenser?
what two places heat be deposited in a water cooled condenser
What does ac condenser do?
Refrigerant enters the condenser as a high pressure vapor. In the condenser, the heated refrigerant is cooled by transferring its heat to the air which passes through the condenser fins, and it changes state to a liquid during this time.
Why must an air cooled condenser be located where the air will not recirculate through it?
It can't
What is ac condenser?
ac condenser means "Air Cooled Condenser". The cooling media is Air. The fluid or anything which is being circulated through (inside) the coils /tube being cooled by the exposed or forced air - which impinges over the outside of the coil / tubes. B.Kannan balakannan@live.com
After heat is absorbed into a condenser medium in a water cooled condenser the heat can be deposited in one of two places what are they?
The heat absorbed by the condenser medium in a water-cooled condenser can be deposited either into the environment through the cooling water, which carries the heat away from the system via a cooling tower, or into another part of the system to be reused for heating purposes, like in a heat exchanger for a district heating system.
