Rear-wheel-drive dirveshafts are measured for the center of the front u-joint to the center of the rear u-joint.
Yes, a meter stick can be used to measure length.
345 mm is a measure of length. A measure of density would have units of mass divided by volume.
By using a tape measure
We can measure how long things are , how tall,or how far apaart they are .Those are examples of length meaasurements. The basic unit of length is meters.
match it with a piece of string then measure the string
The length of the driveshaft on a 1983 Chevy G10 van typically measures around 132 inches, but this can vary depending on the specific configuration and whether any modifications have been made. It's best to measure the existing driveshaft or consult a repair manual for precise specifications related to your specific vehicle setup.
52 or 53" long
Not sure what cable exactly you mean, but the meter is quite appropriate to measure cables in general.
That will vary according to the engine and transmission.
70 inches is usually regarded as the absolute maximum length a driveshaft should be without adding a center support bearing
6ft
that will have to be measured to find that answer.
Depends on length of driveshaft, quality of build, and vehicle it goes on.
In general, you measure it. In a few special cases you may be able to use geometry or trigonometry.
No. In general, you can only convert units that measure the same thing: thus, you can convert length to length, area to area, mass to mass, etc.
Longitud. es la centésima parte de el metro.
Yes it is used to measure length.