answersLogoWhite

0

What else can I help you with?

Continue Learning about General Science

What happens when you put a egg in salt water?

The egg should have its water or substance in the egg come out through the cell membrane. :)


What happens when plant is put into water?

If a plant cell is placed in fresh water, there will be a net movement of water into the cell - because the solute concentration inside the cell is greater than outside. This occurs because the system is attempting to reach equilibrium (where the concentrations inside and outside are equal). Unlike an animal cell, a plant cell will not burst when excess water enters the cell. This is because the cell wall helps the plant cell maintain its structure.


What will the water do if you immerse a living cell into hypertonic solution?

When dealing with cells and their surrounding environment, if the outside of the cell is hypertonic (more salty), water will move out of the cell. This is an effort for the concentration of the salt to even out. The cell will shrink as a result.


A dense area in a cell that contains nucleic acids is?

Nucleus


How does a solar generator work?

There are actually two types of solar generators. The first is a photovoltaic cell. It is comprised of two layers of silicon, one doped and one un-doped. Sunlight excites electrons in the top layer, causing them to travel to the lower layer. This results in an electric potential, or voltage between the two. Electrons then pass through a circuit back to the top layer. The second type uses sunlight to heat water. The heated water then runs a steam-turbine generator.

Related Questions

How do you use muratic acid to clean buildup in cell of a chlorine generator in salt water pool and What are the proportions of muratic acid and water that you pour in to the cell unit?

To clean buildup in the cell of a chlorine generator, first, disconnect the power and plumbing to the cell. Then, create a diluted muriatic acid solution with a ratio of 1 part acid to 10 parts water. Carefully pour the solution into the cell and let it sit for a few minutes before gently scrubbing the buildup with a soft brush. Rinse the cell thoroughly with water before reconnecting it to the system.


What ratio of water to acid should you use to clean your pool cell?

To clean a pool cell, a common ratio of water to acid (usually muriatic acid) is 4:1, meaning four parts water to one part acid. Always add acid to water, never the other way around, to prevent splashing and reactions. It's important to follow the manufacturer's recommendations for your specific pool cell, as concentrations may vary. Always wear protective gear and ensure proper ventilation when handling acids.


What chemicals in a cell?

If you are refferring to a Battery cell in an automobile, the answer is sulfuric acid, and water.


How do fatty acid molecules differ from amino acid molecule?

amino acid molecules are water soluble meaning they cannot enter the cell. Fatty acid molecules CAN enter the cell.


What part of the cell membrane prevents organisms from dissolving organisms from dissolving in water?

The lipid bilayer prevents the cell from dissolving in water.


What part of the cell membranes prevents the cell from dissolving water?

Nonpolar fatty acid chains


Which part of the cell membrane non-polar and prevents the cell from dissolving?

Nonpolar fatty acid chains are nonpolar and prevent the cell from dissolving.


Is a car battery a acid or base?

Wet cell, containing a mixture of sulphuric acid and distilled water.


Is a car battery a acid or a base?

Wet cell, containing a mixture of sulphuric acid and distilled water.


How do you clean turbo cell salt-chlorine genrator?

Remove the cell from its position in the plumbing by loosening the unions on both ends of the cell.You will need a small plastic bucket (6 - 8" opening), water and muriatic acid.Fill the bucket with sufficent water to submerse the cellSet the cell, on end, in the bucket of water.Add 1 part muriatic acid for every 2 parts water in the bucket. Let the cell sit in this solution for 5-10 minutes.Turn the cell over and let the other end sit in the solution for 5 - 10 minutes. You will be submersing the cord, which will not be affected by the mild acid solution.Look in both ends of the cell to confirm calcium deposits are removed. If not, repeat cleaning procedure.Rinse cell with fresh water and replace in plumbing line. Hand tighten unions before restoring power to filter pump.


What is a salt water swimming pool?

A salt water pool has a chlorine generator on it that turns sodium chloride into chlorine gas. The water in the pool is not like the ocean, you can't taste the salt and it doesn't sting your eyes. The water isn't as harsh on clothing, eyes, skin and hair as chlorine is.


What acts as a generator for the cell?

The mitochondria.