It is very important to people who use small harbors, at low water it is often the case that the harbor is dry, the high water tables help them to plan their sailings to arrive when the harbor is accessible.
Also on some beaches high tide covers the whole beach which means no sunbathing and no sand castles being built by the children.
Surfing is also better on the incoming tide, the last few hours before high water is the time for better and more consistent waves.
Too high a resistance is always not a good thing in a circuit. That's what "too high" means.
If the water table is higher the the surface of the land, water will seep out of the land surface and form a puddle, pool or lake. The depth of the water body will increase until the water surface is at the same level as the surrounding water table - this is a state of equilibrium. If the water table lowers, so will the water level in the water body, until equilibrium is reached. Water moves slowly into and out of the land surface and follows the movement of the water table in the area. Don't confuse this with storage reservoirs behind dams. These have an artificially high water level and the surrounding water table can be lower than the reservoir.
A flood can go as high as the land and water allow. There is no limit to the rise of flood waters because a flood is not a controlled event.
pores present in it. affinity for water.
Pure water will have a high resistance, a low conductivity for electricity. If there are ions present, then the conductivity will be greater.
Example sentences:The water table was so high that everyone had water in their basements.The water table was so high that the town could not handle anymore rain.
A flood is more likely to occur over an area with a high water table. A high water table means that the ground is already saturated with water, which can lead to faster runoff and increased risk of flooding during heavy rainfall.
access to water is more available.
Too high a resistance is always not a good thing in a circuit. That's what "too high" means.
B . Because the water table was high enough not to need irrigation
A body of water
The water table is the level below the ground where soil and rocks are saturated with water. The flow of a river is influenced by the water table because it can affect the amount of water available to feed the river. When the water table is high, it can contribute to increased flow in the river. Conversely, a low water table may result in reduced flow in the river.
If you have a pool in a high water table area it should definitely have a hydrostatic valve fitted in the bottom to stop it from becoming so empty that it can start to float. As a mater of fact it would be a good idea to have a system installed whereby water can be pumped from under the pool constantly in case you ever do want to keep it entirely empty.
it evaporates
The water table intersects the surface at the point where the ground is saturated with water. This can vary depending on factors such as topography, soil composition, and precipitation levels. Typically, you can find the water table closer to the surface in areas with high rainfall and near bodies of water.
In wet locations, the water table is closer to the surface because of abundant rainfall and groundwater recharge. In deserts, the water table is deeper due to low precipitation and high evaporation rates, which limit groundwater replenishment.
mound latrine