The number of resistors and their value. The wire and the junction points have resistance also.
Bubbles
Permeability
Ohm so correctly said: Voltage divided by current equals resistance. Voltage divided by current will tell you the value of a circuit's resistance. But resistance is not affected by either voltage or current. It is determined by the length, cross-sectional area, and resistivity (type of conducting material) of the conductor. Resistivity is, in turn, affected by temperature. So voltage divided by current tells you what the resistance happens to be - changes in voltage or current do not affect resistance.
A person will not be able to discuss how the following factors would affect the results of electrophoresis unless they know what the following factors are. This information needs to be included for a person to know the correct answer.
The factors that affect gas exchange in humans include the amount of gases in the atmosphere. It also includes temperature, atmospheric pressure and ion concentrations.
Yes , heat makes epoxies set quicker and harder.
Current Flow I believe.
The core material and the number of windings are major factors. The voltage potential and current run the unit.
Factors affecting the magnetic field strength of a solenoid are: - length of the solenoid - diameter of the solenoid - current through the coil around the solenoid - number of turns of the coil of current around the solenoid, usually turns of wire - material in the core
Yes, additional resistors affect current in a series circuit by increasing the total resistance, which decreases the total current.
From ohms law, I = V/R hence Voltage and Resistance can affect the value of current, both peak and average. Also with a rectifier circuit other factors can affect the peak current such as frequency and capacitance Craig - AUT
One of them is how many coils go around the electromagnet. also the amout of current flow< and the type of core material.
by adding the the resistances in series the total resistance of the circuit increses and thus the crunt flowing in the circuit decrese. Ans 2 . the current in series circuit of constant resistance will always be the same . It will not effect the current .
It reduces the current. As the current travels through the resitors it has some current that is left in the resistor. And
As long as the voltage between the ends of the circuit remains constant, the current through the circuit is inversely proportional to the total effective resistance of the circuit.
water /cement ratio
The ammeter does affect the flow of current in a circuit, however, the resistance of the ammeter is so small in comparison to the circuit that the effect is negligible. It is connected in series.
In a series circuit, all the current passes through the one circuit. Any break will totally remove power from all of the circuit.Parallel circuits have more than one branch where the current can flow. A broken wire will only affect one part, the rest of the circuit will still pass current.In a series circuit, all the current passes through the one circuit. Any break will totally remove power from all of the circuit.Parallel circuits have more than one branch where the current can flow. A broken wire will only affect one part, the rest of the circuit will still pass current.