FeCI2 is a combination of iron and hydrochloride. This solution starts out as a yellowish green color. When the equivalence point is reach the solution turns to an orange brown color.
It changes from the golden color back to a grey color.
The lack of a streak would indicate that the mineral is harder than the streak plate, or the color of the streak is the same as the color of the streak plate.
You seem to be talking about a light wave. If you increase the amplitude the light gets brighter, and if you decrease it gets dimmer. Amplitude has no effect on colour.
If you boil it, the water will boil and the dye will not, leaving you with dye.
Color green is it warm or cool? it is a hard question if you get to deep into the color but really it is a COOL color.
Neutralization occurs at the "equivalence point," where the moles of your acid and your base are the same. A chemical indicator tells you when this point is reached, and changes color appropriately.
Most solutions used in titrations are colorless, therefore you cannot really estimate the equivalence point (the volume of added titrant that causes a stoechiometric reaction). However, slight variations in other factors such as acidity (pH) can be detected by means of an indicator, which will change color accordingly. This will notify you when you have reached the equivalence point.
The indicator should change color right at the equivalence point, so 5.
when the equivalence point of a titration is achieved.. Added: (More precisely:) The equivalence point is the point where the number of moles of base equal the number of moles of acid. The end point is the point where the indicator being used changes color (also 'indication point)'. If the indicator is chosen correctly, the end point will essentially be exactly as near as possible at the equivalence point. The point of the titration is to find the equivalence point -- the end point is just a very close approximation to it. This is because the pH of the solution changes very rapidly close to the equivalence point. Therefore, the indicator will change color very close to the equivalence point because of the steepness of the pH change
The equivalence point is the point where the number of moles of base equal the number of moles of acid. The end point is the point where the indicator being used changes color (also 'indication point)'. If the indicator is chosen correctly, the end point will essentially be exactly as near as possible at the equivalence point. The point of the titration is to find the equivalence point -- the end point is just a very close approximation to it. This is because the pH of the solution changes very rapidly close to the equivalence point. Therefore, the indicator will change color very close to the equivalence point because of the steepness of the pH change.
his grey heart color changes
Phenolphthalein changes from colorless to red in the range of pH = 8.0 to 9.6
Titration without indicator is only possible with another measurement:Examples / possibilities:pH-electrode measurement (acid-base titration)Conductivity measurement (acid-base titration or ion-reaction)Change of color by excess or depletion of the reactant/titrant (redox titration)Precipitation by excess or depletion of the reactant/titrantAdded:(The following was more or less written for 'indicator' titrations, but same principles count for other 'sharply' changing properties):The equivalence point is the point where the number of moles of titrant equal the number of moles of the reactant. The end point is the point where the indicator being used changes color (also 'indication point)'.If the indicator is chosen correctly, the end point will essentially be as near as possible at the equivalence point.The point of the titration is to find the equivalence point -- the end point is just a very close approximation to it. This is because the pH of the solution changes very rapidly close to the equivalence point.Therefore, the indicator will change color very close to the equivalence point because of the steepness of the pH change
the color stays the same
tetriay
Equivalence point is the point at which the reaction is justcomplete. End point is when there is a permanent color change due to the presence of a indicator.
it changes color