Control is an experiment in which either no result is shown or the result shown is consistent for any change in variable.
Independent Variable is the factor the Experimenter alters in order to see the effects on the dependent variable.
Dependent Variable is the exact opposite.
It can be rejected if there is no control variable.
True
you have to decipher out what exactly it is saying buut... participants that are exposed to the independent variable are in the experimental group and the participants who are treated the same way as the experimental group, except that they are not exposed to the independent variable, make up the control group... any...
The factors that distort the way the independent variable affects the dependent variable are referred to as the double-blinds. The factors try to explore the relationship between the dependent and independent variables.
Controls are used to show that the test, equipment, procedure...are working properly. One would expect negative controls to give negative results and positive controls to give positive results. Controls used would depend on the experiment.
It can be rejected if there is no control variable.
If you want really good friends, then they will learn to understand that you are that way. But, if you can control your temper, then it will be easier to make friends. Just remember, good friends like you the way you are.
true
yes
Writing a word ten times is a good way to remember its spelling. Using a word often is a good way to remember a word.
True
Use a variable Frequency Drive. Sold by ABB, Allen-Bradley, and many others.
A variable resistor usually has three terminals, one of which is connected to the 'wiper' by which means its resistance is measured. By using all three terminals, we can control the potential difference in a circuit. When used in this way, we call the variable resistor a 'potentiometer'. By using two of the three terminals, one of which must be connected to the variable wiper, we can control the current passing through circuit. When used in this way, we call the variable resistor a 'rheostat'.
a good thing to remember when you're planning your diet is to eat your way to the blank of the pyramid
The relationship is a matter of cause and effect. An independent variable is given as one upon which another variable depends. So, for example, if you heat a metal pipe, the pipe expands. The amount of expansion is dependent upon the amount of heating that occurs, so expansion is the dependent variable, and the heating, which you may or may not control, is the independent variable. All it means is that if the independent variable ungoes a change, there is an associated and predictable change in the dependent variable. The two are linked inextricably, but one is cause, the other is effect, or to put it another way, you control the change in the dependent variable with input into the independent variable, but it doesn't normally work the other way around.
"Picture a mountain peak" is a good way to remember the definition for zenith.
make a song out of it