The surface area of a marble chip is the area on the outskirts exposed to external factors. It is like looking at a cube, the surface area of a cube is the area on the square sides of a cube which can be touched.
E
Marble is primarily made of calcium carbonate. Vinegar has acid in it. When the weak acid contacts the calcium carbonate, it gives off bubbles of carbon dioxide gas, and eventually will erode the surface of the marble chips.
We can use astoterf on hill to slow the marble
Yes. There are ways to do that, but it depends on what you wish to change the surface area of. Changing the surface area of something like, say, a shotput is difficult, but changing the surface area of a balloon can be accomplished by merely blowing it up (more) or deflating it.
It all depends on what surface it bounces on.Either the ball or the surface changes shape. A rubber ball changes it's shape, but a marble changes the shape of the surface it bounces on. And if the change is only temporary, it snaps back to it's original shape, and the ball bounces.But some energy is lost in the process, and the ball bounces lower each time.Generally a hard surface will make a hard ball bounce higher, since they hardly change shape, and they keep more of their energy. So on an ideal surface a marble would bounce higher than a rubber ball, as long as it doesn't break.Check out liquid metal: http://www.liquidmetal.com/media/ball_bounce_DSL.wmvSkrommel
To fix chipped marble, you can use a marble repair kit or epoxy resin to fill in the chip. Sand the area smooth and polish it to match the rest of the marble surface.
A marble is more dense and has less surface area, so it is not affected by air resistance as much as the feather.
Yes, the smoothness of the surface can affect the speed of the marble. A smoother surface will result in less friction, allowing the marble to roll faster. Conversely, a rougher surface will create more resistance and slow the marble down.
Depending on which definition of "chip" you use, there could be several distinct possibilities. You could strike it with something hard to fracture off a 'chip'. You could, perhaps, slice it into 'chips' with some sort of cutter. You could 'chip' it with a golf club as you would a golf ball (a new sport there?). If 'chip' refers to the throwing of the marble in a game of marbles, there are probably as many techniques as there are players. A common technique is to hold the marble with your forefinger in a 'U' shape and your thumb under or behind the marble. Then flick the marble at your target with your thumb. There are many other techniques but remember, practice makes perfect.
The paper has more surface area and therefore more air resistance than the marble does. If you wad up the sheet of paper in a tight ball, you'll see very little difference in the falling speed.
if the particles are really small, ie, a powder form, the reaction will be a lot quicker because there is a larger surface area. if the marble is in larger chips, the surface area of the marble is smaller therefore the reaction is slower.
elements in a marble chip is not far fetched. They are: calcium, carbon and oxygen. otherwise known as CaCO3(note the three is below and not on the same line.
You can speed up the chemical reaction between lemon juice (acid) and marble (calcium carbonate) by increasing the temperature, crushing the marble to increase surface area, or using a catalyst like citric acid to enhance the reaction rate.
i think that your data is inconclusive
Okay, I will explain to you that, in the rainfall should had some kind of chemical like alkali, acid, salt, aldehyde, etc. Specially acid will interact with marble which contains calcium carbonate (CaCO3) to make the salt and liberates water vapour. The reason that surface of marble is not uniform as metal, so when the acid penetrates to the marble will make the result with porous coefficient differently. And you can see this very obviously this marbles surface will be rough touch. Of course this is long process not immediately after you fix the marble at the exposed area.
The area of Marble Mountains - Vietnam - is 37 square kilometers.
The area of Marble Mountain Wilderness is 978.303 square kilometers.