no it only depresses if you apply pressure. If the finger is just resting on it the liquid inside will remain there.
when you push the plunger are the air particles closer together in the syringe or in the bubble
If you push the plunger of a syringe filled with air and let go, it will come back up again! :) :P
by showing at what point it stops behaving like air (the pressure at which it condenses to a liquid).You can show that air has maximum compressibility using 3 syringes with one sealed with water, the other with air, and the other with chalk whereby the one with air will allow compression to the highest degree compared to the rest.
It everywhere in the air. In fact is takes up about 50% of the earth's atmosphere. Everytime you exhale, you are releasing carbon dioxide into the air while plants take this in for photosynthesis.
A gas syringe is used to measure and dispense liquids or insert and withdraw a volume of gas. These syringes vary in sizes and can collect from 500 ml to 0.25 ml of gas.
When you push the plunger of a syringe down into a marshmallow, it puffs up with air. When you pull the plunger of the syringe up while it is in the marshmallow, it will shrink.
The mass in the syringe, as you push down the plunger.
Measure to the edge of the plunger (or piston) where it touches the inside of the syringe cylinder. http://www.northcumbriahealth.nhs.uk/palliativecare/clinical/syringe/05.php
he pushes the plunger so that he removes the air molecules from the syringe and make it vacuum and then puts it in the medicine and pulls the plunger so that the liquid rises without the air molecules getting in the syringe (arjun)
when you push the plunger are the air particles closer together in the syringe or in the bubble
To ensure that the plunger can move and not stuck. Because if it is stuck, when the gas goes into the syringe, the plunger will not move back and so the values you received will be lower than the actual value
If you push the plunger of a syringe filled with air and let go, it will come back up again! :) :P
The easiest way to dissolve trimethoprim for oral administration is to drop the tablets into a 60cc syringe - pull the plunger out then drop the tablets into the body of the syringe. Put the plunger back in and depress it until the tablets can't rattle around. Fill a small glass with tap water, then pull water into the syringe. Place a fingertip over the tip of the syringe to seal it, then shake the syringe to get the tablets to dissolve. This may take a few minutes, and the resulting paste/gel/liquid is not going to taste good to your pet so expect to need some help restraining him/her to give the medication.
The pressure generated by a syringe is a result of how hard the plunger is pushed and the internal diameter of the needle, not the size of the syringe.
The easiest way I have found is to pull the plunger out of a large syringe (60 cc works great). Drop the tablet(s) into the front of the syringe and put the plunger back in. Run tap water from a faucet and stick the tip of the syringe into the running water. Pull back on the plunger to get 20-30 ccs of water in the syringe - it should be about half full. Turn off the faucet and place your index finger over the tip of the syringe. Shake until the tablets are dissolved, then use the syringe to "inject" the slurry into your dog's mouth.
When the plunger is pulled, the volume inside increases. This reduces the pressure inside, and the air pressure outside forces liquid in, in an effort to make the pressure inside and outside the syringe equal again.
A syringe with a calibrated barrel, plunger, and tip, used with a hypodermic needle for hypodermic injections and for aspiration. (Medical Dictionary)