0
Which PNP device has a terminal for synchronizing purpose a) SCS b) Triac c) Diac d) SUS?
Wiki User
∙ 9y ago
Scs
Anonymous
Anonymous
4
Add your answer:
Earn +20 pts
How does triac works?
Triac is Three Layered Device . Emitter ,Collector and Gate
How can you identifies lead of triac?
A; Invariably the gate will be be smallest terminal available
What is the difference between a DIAC and a TRIAC?
A DIAC is simply a diode that breaks down at predictable voltage.A TRIAC is a 3 terminal device that will conduct whether the anode is at a positive or a negative potential, controlled by a gate.Another answerThey are AC versions of the SCR and diode respectively. Do you need more details?
Is thyristor a current controlled or voltage control device?
Triac is the current control device.
What signal allows AC to flow through terminal T1 to T2 on the Triac?
A: It depends on the current load but the Small terminal is the gate that will allow the triac to conduct. However the gate cannot be used to shut it off, The only way to shut it off is t reduce the current below the holding current or revering the polarity for the triac when conducting
What is optocopler?
A: It is an IC which contain an led which will couple the input to another device within the package it can be a transistor a triac scr and so forth. is main purpose in application is to isolate the source from the output.
The device which acts like an NPN and a PNP transistor connected base to base and emitter to collector is?
Triac
What is the name of the scr or triac triggering system that triggers the output device at the same point on each ac cycle?
Diac
What is the population of Triac-Lautrait?
Triac-Lautrait's population is 454.
Difference between diac and triac?
The diac and the triac are used to control the AC lines. The difference is that triac are bigger than diac.
Assume the triac of an ac output module fails in the shorted state how would this affect the device connected to this ouput?
If the triac of an ac output module fails in the shorted state, the device connected to the output would behave the same as if it had been connected directly to the ac power supply. It would run at full power and it would not be controllable.
What is the area of Triac-Lautrait?
The area of Triac-Lautrait is 6,400,000.0 square meters.
