0
Which cross sectional view correctly shows the general shape of the stream bottom between points a and b?
To accurately depict the stream bottom's shape between points a and b, one must consider factors such as the gradient of the stream, sediment deposition, and erosion patterns. Typically, a cross-sectional view would show a concave shape if the stream flows smoothly, reflecting a gradual slope. If there are areas of erosion or deposition, these would create variations in the cross-section. Therefore, the correct view would illustrate these features, showing a realistic representation of the stream's bottom profile.
What else can I help you with?
Water oil glycerin how will they be layered?
Water on bottom, oil on top and glycerin between them.
What is difference between nominal and working capacity in storage tanks?
1. Nominal capacity is volume from the bottom up to the top of the shell 2. Working capacity is volume between LLL and HLL
In newton's ring how does interference occur?
Newton's rings are formed due to interference between the light waves reflected from the top and bottom surfaces of the air film formed between the lens and glass sheet.
What is the definition of wavelength in units?
the distance between two consecutive compressions or rarefactions of a light wave is called its wavelength.
What hazards can argon gas pose to humans?
In general none. However, argon is often used to clear out tanks which are filled with explosive or combustible gases. Argon, being a dense gas will collect at the bottom of such a tank and poses a risk of death by asphyxiation.
How to wipe your bottom correctly?
Front to back.
Where on your tongue is your sweet taste bud?
the bottom of your tongue if i remember my science class correctly.. the tip. yeah it the bottom
does it leave a spatula mark on the bottom of the bread?
No this item would not leave a spatula mark on the bottom of bread if it is used correctly.
If a cylinder holds a volume of 100 cm and is 30 cm tall which is the area of the bottom cylinder?
I assume the volume is 100 cubic cm and NOT 100 cm. The volume of a cylinder is cross-sectional area * height 100 = cross sectional area * 30 so that the area of the bottom, or cross section, is 100/30 = 3.333... sq cm
What sentences uses the participle phrase lying in the bottom of the chest correctly?
The necklace, lying in the bottom of the chest, had been forgotten for years.
How do you fill in the spaces between your ABS plastic radio install kit if it does not fit correctly?
For anyone who answers this, reference http://forums.nicoclub.com/zerothread/337573 The second picture from bottom is my problem. Thank you!
How do you correctly use a microscope?
by using two hands and holding it very gently on the bottom and on the arm.
Which of the following correctly lists the layers in order from oldest to youngest?
The oldest is on bottom and youngest on top.
How many bottom teeth does a dog have?
As a general rule dogs have 22 teeth on the bottom, and 20 on the top.
How do you set the jewels correctly on nabooti island?
From top to bottom, Purple Green Red White Blue
How many psi do 1 gallon of water create?
It all depends upon the shape of the container that it is in. For example, if the water weighs 8 lbs per gallon, then the water at the bottom of a container that is a vertical pipe with cross sectional area of 1 square inch will exert a pressure of 8 psi. However, if the water is in a vertical pipe with cross sectional area of 8 square inches, then the pressure at the bottom of the pipe will be only 1 psi.
What is different between the top and bottom side of an earthworm?
how can you distinguish between the top and bottom side of an earthworm
