As engine has to work hard and engine RPM are high its temperature rises and water pump also works faster and hot water reaches temperature sensor fast and suddenly needle goes up.
Type your answer here... A substance with high specific heat means it can absorb alot more heat energy before its temperature increases. A substance with low specific heat cannot absorb alot of heat energy so its temperature increases quickly because it cant absorb the heat. Remember there is a difference between Heat energy and Temperature. The ocean can absorb alot of heat energy but still feel like its cold in temperature. The tip of a needle can be at 1000 degrees temperature but there is hardly any actual heat energy in it because its so small.
Only if the needle was made of iron or copper
because a ship has a wider area to spread it`s surface on and a needle does not because a ship has a wider area to spread it`s surface on and a needle does not
Most conifers have needles that serve the same purpose as leaves.
you order chinese??? you order chinese???
For a 2005 Ford Ranger, the temperature needle should generally be positioned in the middle of the gauge when the engine is at normal operating temperature. This typically occurs after the vehicle has been running for a while, allowing the engine to warm up. If the needle is consistently in the red zone or below the cold mark, it may indicate a problem with the cooling system or temperature sensor. Always refer to the owner's manual for specific guidance regarding your vehicle's temperature gauge.
Eeeew, No! If anything, it would coat the needle with any oil naturally present in your hair.
Check the operating temperature with a thermometer - if within normal limits replace the temperature sensor if overheating write back - many things to check
needle-like leaves
Mosquito body temperature can be measured using non-contact infrared thermometers or thermocouples attached to their bodies. Their environmental temperature can be measured using data loggers placed in their habitat.
why is the temperature gauge not moving on a 2007 Lincoln mkz
if you don't have an 'eye' for evenness, take a ruler and draw a line with a removable ink pen. thread your needle and know the end. poke the needle up on the line and then down again a distance down the line you made. repeat for the length of the line. it will look like... _ _ _ _ _ _ _ _ _ _
Your Keurig may be running slow due to a clog in the machine's water line or needle. This can happen if there is a buildup of mineral deposits or coffee grounds. Try descaling the machine and cleaning the needle to improve its performance.
you don't. spend the $20 and go get it done professionally.
Defective temperature sensor or bad gauge
Think about this for a minute and you'll figure it out! Which would hurt less when it went into your skin? Something sharp goes in quickly and easily, but a blunt needle would be harder to get through the skin.
the normally position of needle in temperature gage is a half of gage.