Because, if you're distracted (and thus delayed) after you turn on the gas, there could be a build-up which may explode ! Lighting the match before turning on the gas supply, means any escaping gas will quickly ignite.
The red light should blink for three minutes, then turn off for three minutes. Then it should repeat the cycle. That is how you know it is working. If the red light stops blinking completely then the unit needs to be replaced.
there should be a knob on the bottom, make sure that it is loose, turn the top of the burner like you are unscrewing it, then turn the gas on, use a striker or fire starter to light it over the top, you should hear the gas moving through it before lighting it
It should only take one person to switch on a light bulb if it is 6 light bulbs it may take 6 people to switch on a light bulb Der!
The fridge light should turn off when you close the door. The light is hot because not all the electricity is turned into light - an awful lot is wasted in the form of heat.
Remove the slide ,return the scope to low powered and ,turn off the light .
u get the combination(3 #s) and do the combo. First turn right and match the number, then turn left twice and match the number, and then turn right and match the number. Then the lock should open. Hope this helps!
Don't light it! If you have ever ever ever watched Looney Toons then you know what happens if you light a match and it happens to be filled with TNT and explosives. If I had one match and entered a dark room, I would flip on the light switch to find the candle.
To reset a motion light, first turn off the power to the light at the circuit breaker. Wait for a few minutes, then turn the power back on. This should reset the motion light and it should start working again.
You need a scan tool. However, you should not turn off the light without repairing the problem that is causing the light in the first place.
You take a match, light it up and turn the knob on the side of the burner.
you click on the light and it should turn on
You take a match, light it up and turn the knob on the side of the burner.
To install a light switch with an indicator light in your home, you will need to first turn off the power to the circuit. Then, remove the existing switch and connect the wires to the new switch, making sure to match the correct wires. Finally, secure the new switch in place and turn the power back on to test the indicator light.
I recall that NY State published a new rule (maybe 20 yrs ago) which stated that you should allow the first car facing you to make a left hand turn when the light turns green. Don't know it that is still in affect.
at
why
You should be able to turn the knob and it should light. If it doesn't and it's very old, and you can hear gas flowing, you need to light it with a match when you turn the knob. If it's newer, then the pilot is probably out. You can light it by pushing the red safety button (usually in the left side storage compartment if it's a one-oven stove or under the top of the stove if two ovens) and putting a match to the pilot at the back top of the broiler for the oven and under the middle of the griddle for the burners. You may have to hold the button in for several seconds before it will stay lit.