Same thing consider the following Long turn ell ( Sweep) regular sweep and short sweep = 1/4 bend all are 90 degree fittings
The filet is part of the radius, therefore making the term filet radius. A filet radius measures an inside corner. A corner radius measures an outside corner.
radius is half and diameter is the whole Expanding theabove statement: Diameter is the width of a circle; Radius is one half the width. In math, the radius refers to the distance from the centerpoint of a circle out to the edge.
Curvature is a general term to describe a graph. Like, concave or convex. Radius of curvature is more exact. If the curve in a 'small' section is allow to continue with the same curvature it would form a circle. that PRETEND circle would have an exact radius. That is the radius of curvature.
In geometry, a radius is a line segment that connects the center of a circle to any point on its circumference. The plural form of radius is radii, which refers to more than one radius within the same circle or sphere. So, the main difference between radii and radius is that radii is the plural form of radius, indicating multiple line segments from the center to the circumference of a circle.
An angle is measurement use to tell the distance between two lines that are concurrent at a point. An arc is the length of a curve drawn with a unchanging distance (radius length) around a point..
no difference
a radius is half the diameter of a circle
A diameter is a whole line and a radius is just half not a whole that is the difference
The radius of a circle is 1/2 of the diameter.
The difference between the 2 is length and curvature. A short radius elbow offers a tighter turn than the long radius. The short radius elbow is cheaper and will fit into a tighter space.
the word 'radius-es' doesn't exist, the word 'radii' is the plural of 'radius'
There is no difference. Different suppliers and contractor describe the same situation with 3R or 3D. Here is how to think about it. A piping segment is formed or bent at a radius. The radius is measured at the centerline of the bend. The radius of the bend centerline is 3 times the nominal diameter of the piping segment being bent. 3R means the bend radii is three times the nominal pipe diameter. 3D means three times the nominal pipe diameter is the bend radii of the piping segment. Caution don't begin to convert 3R to 1.5D. Not applicable with this terminology. Standard long ells can be purchased with 3R bends, being 10 inch pipe ells have a bend radii of 30 inches.
The filet is part of the radius, therefore making the term filet radius. A filet radius measures an inside corner. A corner radius measures an outside corner.
surface area is the area of a 3D object radius is half of the diameter of a circle
The formula for the circumference, (C) of a circle is C = 2πr.....where r is the radius. Let R be the radius of the larger circle and r the radius of the smaller circle. Then 66 = 2πR - 2πr = 2π(R - r) Then R - r = 66/2π = 33/π ≅ 10.504 The difference between the two radii is 10.504 (3dp)
A circle has a constant radius whereas an oval does not.
One has a penis and one a vagina