There are dozens of torque specifications, for the 2002 Saturn. A complete list of torque specifications, can be obtained from most General Motors dealerships
There is no real difference. The two terms refer to a smaller computer, designated net book by some companies and note book by others.
The sheave height is the distance between the shortest distance from the tip of the sheave (commonly called a "boom") and the ground. It is common to discuss the sheave height with respect to a piece of equipment and get a number which is the maximum sheave height.
The client brief and the design brief are not the same. The client brief states the client's issue and what the client expects. The design brief has to do with the design of the project.
This was a building that housed the winding Engine. This was the engine (usually steam) that operated the hoisting equipment. This moved miners, equipment, and mined product (usually coal) vertically in the mine.
support the headgear
Because of the pressure of the headgear
They lift the miners and their tools ..so that they can go up and down
TRANSPORT MINERS UNDERGROUND
BECAUSE THE SHAFT IS 500 POINTS FROM HERE
They lift the miners and they tools,so that they can go up and down
winch and sheave
WINCH AND SHEAVE
What do these two parts of the lift do
The winch on the right has two sheave wheels and a counterweight
A sheave (/ʃiːv/) or pulley wheel is a grooved wheel often used for holding a belt, wire rope, or rope and incorporated into a pulley. This allows the wire or rope to move freely, minimizing friction and wear on the cable. Sheaves can be used to redirect a cable or rope, lift loads, and transmit power. A sheave (pronounced “shiv”) is actually part of the pulley system. The sheave is the rotating, grooved wheel inside the pulley.
What do you think a countweight does for a mine winding system.