0
Rate this Study Guide:
☆☆☆☆☆slip speed control refers to induction machines
s=(synchronous speed-motor speed)/synchronous speed
by varying slip the machine can be either be operate in generated mode or motor mode
- Remove the fan belt.
- Connect a jumper from generator DF to the frame (or generator D- pole, if it exists).
- Pick up battery plus with a jumper cable and touch the generator D+ pole - the generator should start spinning. Do this only for a few seconds to avoid overheating. The generator is polarized now.
The complexity of the American federal system encourages separation of power among the three arms of government. It also encourages the sharing of power between the central government and the states.
A Synchronous Capacitor is a synchronous motor run at no load and is under excited. It is there purely to correct the power factor. It will act as a source of reactive power to your system.
The main difference between synchronous generators and synchronous motors is that a synchronous generator supplies power. Otherwise, it would be just like a synchronous motor.
synchronous motor is a constant speed motor because it will only run at a synchronous speed or not at all.the speed can be changed by changiing the frequency only ns=120f/p
effect of synchronous speed
parallel operating system is tha sharing of data between two computers.......
Distributing system is the sharing of data among different computers....
A generator bus is the bus that connects the generator to it's generating transformer.
If the frequency of the oncoming generator is slightly higher than the system frequency, the phase angle between the system and generator voltages will slowly change at a frequency equal to the difference between system and generator frequencies.
mainly alternator,synchronous motor comes under the synchronous machine.a synchronous motor is not a self starting motor.if a synchronous motor moves with more than synchronous speed then it acts as a synchronous generator.
The torque which is produced during the starting of motor is simply called as starting torque.
"There are many classes offered in the california design college. Environmental design classes, art, painting, scultping and drama classes. Many different forms of design are availible."
We shall use Synchronous machines where inductive loads are more. Due to Inductive loads power consumption will be more due to leading power factor. To compensate this we shall use synchronous motor to improve the power factor.
Shiva Kumar.N
MBNR,AP
Power sharing between two areas occurs through these tie-lines. Load frequency control, as the name signifies, regulates the power flow between different areas while holding the frequency constant.
The shaft of an AC induction motor rotates because of the torque created by the interaction between the magnetic field of the stator and the magnetic field of the rotor.
Directly proportional. Greater speed - greater distance.
deep bars in the rotor that result in higher rotor resistance at low speeds thus resulting in larger starting torques. The higher resistance is due to the skin effect.
dc generators and motors have armatures
synchronous motors or generators have a permanent or dc magnet in the rotor
The interlock is used to prevent the service supply and the generator supply from being inadvertently paralleled to each other.
An amortisseur winding is a squirrel cage winding placed near the surface of the pole faces of a synchronous motor.
