0
What else can I help you with?
What was Jim Swigert doing when the explosion occured?
Jim Swigert was the command module and he was in the command module, but both Jim Lovell and Fred Haise had gone to the lunar module, just before separating.
Day 3 Apollo 13?
On the third day of Apollo13 mission, just as the astronauts were getting ready to separate from the command module, Lovell had gone to do the final check up before they went in the lunar module, the command module exploded.
Which part of the entire Apollo V moon vehicle was the last to be jettisoned during the mission?
The Service Module, jettisoned after returning to earth, but before the Command Module began reentry.
Where is the airbag module 97 jeep wrangler?
Driver's airbag module - on steering wheel. Passenger airbag module - dashboard, right side. Airbag control module - under center console in front of the gear shifter. Please remove the battery connections and wait AT LEAST 30 minutes before touching anything.
What technology does a DIMM that holds data and amplifies a signal before the data is written to the module?
Registers
How do you test blower control module on 1997 corvette?
You need to disconnect it from the circuit before you test it for resistance.
How do you change the ignition module on 1995 f-150 ford?
To change the ignition module on a 1995 Ford F-150, first disconnect the battery to ensure safety. Locate the ignition module, which is typically mounted on the distributor or nearby. Remove the screws or bolts securing the module, then disconnect the wiring harness. Install the new module by reversing these steps, ensuring all connections are secure before reconnecting the battery.
Did Apollo 11 circle the moon before it landed?
Yes Apollo 11 did orbit the moon before it landed on the moon.
Audi 2000 a6. Abs light turned on and brake light is blinking how do you fix this?
take it to a garage take it to a garage more than likely its your ABS module. def. find someone to run a diagnostic on it first before you get a new module. Dont buy a new or reused module either. take you old module out and have it rebuilt. you can get the module rebuilt for 100-200 dollars. a used module will go out on you very soon and a new module will cost at least 1000 bucks. if its not the module, check your abs sensor and your brake sensors from your brake pads. i had the same problem and my abs module was dead and i also had a short in my wear sensor for my brakes.
How do you replace the ABS control module on your 2003 Volvo s80?
To replace the ABS control module on a 2003 Volvo S80, first, disconnect the vehicle's battery to ensure safety. Remove the necessary components to access the ABS module, which may include the air intake duct or battery tray. Unplug the electrical connectors from the module, then unbolt and remove the old module. Install the new ABS module by reversing the removal process, ensuring all connections are secure before reconnecting the battery.
How do you install mas module 1991 Mercedes sl?
To install the MAS module in a 1991 Mercedes SL, first disconnect the car battery to ensure safety. Then, locate the MAS module, typically found behind the passenger side footwell or under the dashboard. Remove any screws or clips securing the old module, disconnect the wiring harness, and carefully replace it with the new module. Finally, reconnect the wiring, secure the module in place, and reconnect the battery before testing the system.
Where is the ignition control module located on a 1992 Chevy S-10 Pickup?
The Distributer module on "92" S-10 Vin code "W" or "Z" is located on the distributer,you must remove the distributer cap to gain access to the ignition module. Once you have gained access to the ignition rotor it is always necessary to always test the module before replacing it.
