it cant.
With it only being a 150 driving miles from one airport to the other I doubt if Southwest will offer this flight. This is more suited for a small commuter airline.
BUI is Boating under influence, compared to DUI or Driving under influence.
The cost for a defensive driving course online can be minimal, especially compared to the benefit you may receive by participating in one. The Department of Motor Vehicles endorses many of these course.
Between living near and around campus, San Diego State University is considered a 'commuter' school where driving to and from the greater San Diego metropolitan area is common.
Driving on an expressway is different from driving on regular roads because expressways typically have higher speed limits, limited access points, and multiple lanes for traffic flow. This can require drivers to maintain a higher level of focus and awareness compared to driving on regular roads.
I bought a 2008 Goldwing a few weeks ago to use as a commuter vehicle to save some money on fuel. I'm getting 43-45 MPG on my 2008 Wing, with most driving being at highway speed...I suspect others milage will vary depending traffic, load (carrying a passenger) etc, but 40+ MPG isn't bad compared to the 16-17 MPG of my Dodge Ram pickup!
To take the commuter rail (MBTA) from Providence to South Station takes about an hour to an hour and fifteen minutes depending on when you go. Driving takes less time usually (excluding parking) but if traffic is bad it can take longer.
The answer depends on compared to what? Compared to driving at 50 km per hour, the braking (not breaking!) distance would be longer, compared to 200 km per hour it would be longer.
the difference between driving a bus as compared to a car is with a bus you need to make wider turns and with a car you can just go for the turn
The distance traveled by a truck driving at a constant speed compared with time.
Fuel efficiency is measured in miles per gallon (mpg) higher on the highway compared to city driving because on the highway, vehicles can maintain a more consistent speed and encounter fewer stops and starts, which leads to less fuel consumption.
Eccentric shafts provide more strength and the support bearings are placed closer to driving points compared to crankshafts.