Well I take my blisters of by poking it with a needle or something sharp and then just let it pop. Beleive me it works and it doesn't hurt.
No, freezing off a blister does not hurt and it will just take a second.
Do not pick at the herpes blister.
a blister takes about 1-2 weeks to heel just as long as you don't pick it
Only thing you can do is give it time to heal.
Yes it will dry up and fall off. That's if you leave the blood blister alone and without popping it off with a needle. Be sure to use a ointment to cure the blood blisters.
5 to 7 days.
The best way to care for a Blister is to allow it to heal naturally. Take care not to pop the Blister, as this will cause pain and possibly infection in the afflicted area. The Blister should eventually burst itself after new skin has formed beneath the area.
if its already dried wait for the scab to come off and then if there is still puss in there take a sterilized pin or needle and poke it
A blister hurts the worst when the raw skin contacts air. If the blister has popped, try to remove the loose skin and then put some cream or antibacterial ointment on it and cover it with a bandage (band aid). Keep covered for a few days, replacing bandage when needed. If the blister has not popped, you need to pop it but in a way you may find difficult. Take a sterilized needle and insert it in healthy skin (not affected by the blister) just outside the blister going under the blister to make a hole. After the hole is made via under the blister, squeeze all the fluid out through the hole. This will prevent the raw skin from contact with the air preventing added pain. You may need to do this a few times a day if the blister refills with fluid, but there should be no reason to cover with a bandage unless to prevent wearing against something. This should heal in a few days and the top skin of the bubble can dry and come off.
A blister on the labia
A water blister is a blister that has filled with body fluid. It is uncomfortable but can be easily reduced to what amounts to a layer of skin over the tender area below it. Use a sterile needle (I have used a sharp knife's pointed end) to drain the water at the base of the blister. There should be very little pain. Cover the blister with a bandage for a day or two until the proud skin forms a hard covering and simply peels off.
In the context of blister copper, "blister" refers to the appearance of the copper after it is extracted and processed. Blister copper contains gas bubbles that form during the smelting process, giving it a blistered or bubbly appearance.