0
What else can I help you with?
How much does a 1988 mariner 75 hp motor weigh?
303 pounds 20 inch shaft
How much horsepower does a 420 cc predator horizontal shaft ohv gas motor have?
It's a 13hp 4stroke motor, nice for pressure washers. Even better for go-karts!
How much does it cost to repair a Saturn's crank shaft?
ur better off buying a new motor. or a slightly used motor from a junk yard. or sell the car to someone very stupid.
How does the drilling machine operates?
A motor rotates a shaft that carries a drill. -A much better explanation is available if you specify WHICH 'drilling machine' -rather than such a broad definition.
How much does a axial commercial fan cost?
how much does a commercial axil fan cost
What happens to motor if too much oil is in it?
the crank shaft whips the oil into a froth… the froth does not lubricate the moving parts… the moving parts try to stop moving… the end
How much is Neptune tilted on its axis?
Neptune has an axial tilt of 28.32°
How much money did Shaft gross worldwide?
Shaft grossed $107,190,108 worldwide.
How much money did Shaft gross domestically?
Shaft grossed $70,327,868 in the domestic market.
Which structural joint type in not commonly found in the axial skeleton?
The synovial joint is not commonly found in the axial skeleton because it allows too much mobility for the axial skeleton where protection and support of internal organs calls for immobility. The axial skeleton consists of the bony and cartilaginous parts that support and protect the organs of the head, neck, and trunk.
Would a 454 small block fit in a 1994 ford taurus sho?
Not much room for a big motor like that, and how would you get a drive shaft to the rear, and what would you use for rear axle.
On your '96 Toyota Tacoma the air fan keeps slowing down until you have your passenger kick the fan area what could be wrong?
Most likely the blower motor is going bad. If the motor brushes are worn it will slow down due to too much resistance between the motor contacts and brushes. When your passenger kicks the fan area it jars the motor and better contact is made, much like smacking a defective starter with a hammer to get it to work. The motor is not servicable and will need to be replaced if it is bad. Check the voltage drop across the motor when it is on high. If it is dropping battery voltage while running slowly the motor is bad. My fan on the same vehicle started doing that and I noticed when I took it out and held it upside down it would run perfect. I pulled up on the fan while hitting the shaft with a hammer thinking I could put a washer under the fan because I thought it may be rubbing? I couldn't get the fan off the shaft but noticed that it moved up the shaft a wee bit and would run perfect no matter how I turned it. I put super glue on top of the shaft and fan area and it has run happily ever after.
