0
What else can I help you with?
What blood component plugs broken blood vessels to avoid excessive bleeding?
i dont know the answer \
What plugs broken blood vessels to avoid excessure bleeding?
blood
What plugs broken blood vessels to avoid excessive bleeding?
It begins with platelets but later fibrin forms a web that traps blood cells that officially forms the clot.
What causes throat bleeding?
I guess its excessive heat in body that causes bleeding. Try taking more water and fruits. Avoid spicy food.
What are some common reasons for broken guitar strings and how can I prevent them from happening?
Common reasons for broken guitar strings include excessive bending, improper tuning, old or worn strings, and aggressive playing. To prevent broken strings, make sure to tune your guitar properly, avoid excessive bending, replace old strings regularly, and play with a lighter touch.
Your industrial piercing is bleeding from no obvious signs of trauma including while sleeping how much bleeding is 'normal' and should you always clean the clotted blood right away?
Bleeding is due to the small vessels in the ear cartilage having been cut. Partly due to the piercer not looking at the cartilage piercing carefully enough to avoid damaging the vessels structures. Bleeding will occur with all cartilage piercings, how much depends on the location of the vessels. Don't clear the clots away from the piercing (this is the bodies way of plugging the leak) allowing the clots to stay for 24 hours will allow the body to close the damaged vessels from the inside out. Washing the piercing under running water will rinse the clots away and not irritate the piercing thus preventing the piercing from bleeding again. The bleeding should ease within 24 ~ 48 hours.
How do you avoid excessive flatus?
less tacos
How do you avoid defects such as undercut and burn?
avoid the excessive heating of base voltage
What 3 things should a nursing mother avoid?
A nursing mother should avoid Foods with Trans Fats, Excessive Alcohol and Excessive Caffeine
How you avoid defect such as undercut and burn through?
avoid the excessive heating of base voltage
How do you avoid defects such as undercut and burn-through?
avoid the excessive heating of base voltage
How do you avoid defects such as undercut and burn through?
avoid the excessive heating of base voltage
