250
60psi
The suction pressure of an R22 unit on an 83-degree day will vary depending on factors such as indoor temperature, coil condition, and humidity levels. A typical range for suction pressure on an R22 unit could be around 60-70 psi on an 83-degree day. It's important to refer to manufacturer specifications and consider other system parameters for an accurate assessment.
265 PSI which equals 120 Degrees Fahrenheit, basically you add about 30 to 35 degrees to the outdoor ambient temperature example 90 degree day at 30 to 35degrees which equals 120 degrees on the high side
The condensing temperature for an R22 system with a head pressure of 296 psig would typically be around 120-130°F. This is based on the saturation temperature corresponding to a pressure of 296 psig on the R22 pressure-temperature chart.
No, R22 is for refrigerators and home AC. It runs at a different pressure and you can't use one for the other.
Low predsure very high
The pressure for R22 refrigerant varies depending on the temperature and phase of the refrigerant. For example, at 40°F, the pressure can be around 60 psi on the low side and 185 psi on the high side. It's important to consult a pressure-temperature chart for specific values.
R22
The recommended suction pressure for R22 varies depending on the specific operating conditions and equipment. However, typical suction pressures for R22 range from 60-70 psi for air conditioning applications. It's important to consult the manufacturer's guidelines or an HVAC professional for specific recommendations.
Liquid subcooling is the difference between the condenser outlet temperature and the saturation temperature of the refrigerant. For R22 with a condenser outlet temperature of 108°F at 260 psig, the saturation temperature is approximately 94°F, resulting in a liquid subcooling of 14°F.
R22
The pressures depend on the temperatures so it is not possible to give "normal" temperatures. The pressures change with the outdoor and indoor temperatures. You need to be EPA certified to attach gauges to the unit to check the pressures.