with white spirit. (its a fact)
Use Goo Gone, it will remove it.
To effectively remove latex paint from a surface, you can use a few methods. One common way is to scrape off the paint using a putty knife or scraper. Another method is to use a chemical paint stripper specifically designed for latex paint. You can also try using a heat gun to soften the paint and then scrape it off. Be sure to follow safety precautions and instructions when using these methods.
It depends on whether it is a water (latex) based paint or a oil based paint. If it is oil based paint it may not come out, but if it is a water (latex) based paint use 'Goof Off' or other latex paint removers with a wire brush. I have used 'Muriatic acid' on some concrete appications.
No. Once latex paint has frozen, it is ruined.
There are several ways to remove paint from a wood deck: * Use a pressure washer to remove the paint. * You can use a sander to remove the paint. This metod takes a lot of time. However, it is the safest way. * There are chemical paint removers. However, you wll need to be extra careful using them. Their fumes are toxic.
I M NOT A GOOD PAINTER ,I GOT PAINT ALL OVER THE WINDOW TRIM AND WALL TRIM .HOW DO I GET THAT PAINT OFF WITH OUT MESSING UP TRIM
yes but not the other way around the latex passes moisture
If it's not synthetic latex, go to the store and look for a product called Goo Gone Power spray... It disolves latex paint, so I assume it will take the latex off of the carpet backing as well.
Oil based paint is best removed with mineral oil or heavy cream like a cold cream. Do not use paint thinner on your skin, it is way too harsh. For latex paint, use soap and water, if the paint is dried use hand cream of baby oil.
What do you mean? Yes, paint on wood trim is typically latex these days. Some older homes may still have alkyd (oil), though. To find out for sure, put a little nail polish remover on a cotton swab and rub it on the paint in an inconspicuous location. It it gets soft and starts to come off, it's latex. Either way, sand it lightly and recoat with the same type of paint and you're good. If you're asking about bare wood, DON'T USE LATEX! The water will swell the grain of the wood. Use an oil primer that is made to take latex topcoats.
There isn't an easy way- hard work is the way to go.