answersLogoWhite

0

tanning should have no effect on the screws in your knee. It would just be like wearing jewelry in the tanning bed, no big deal! It doesn't heat up enough to effect the metal in your knee or anywhere else on or in your body.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Can you use a tanning bed with titanium screws and plate in your lower back?

Yes, but tanning is still bad for you!


Will a tanning bed affect the metal plate in my head?

n0


Can you go to a tanning bed if you have screws and a plate in your leg?

Yes, you can generally use a tanning bed if you have screws and a plate in your leg, as these implants are typically made from materials that are not affected by UV light. However, it's important to consider your overall skin health and any potential for sensitivity or irritation in the area where the implants are located. Always consult with your doctor before using tanning beds, especially if you have underlying health concerns or if the area is still healing.


Is it safe to use a tanning bed with titanium rods and metal plates in your body?

Oh, dude, using a tanning bed with titanium rods and metal plates in your body? Yeah, sure, if you're looking to audition for the next Terminator movie. But seriously, it's not the best idea because metal can reflect and intensify UV rays, increasing the risk of burns or other skin damage. So, like, maybe stick to natural sunlight or embrace your inner vampire instead.


Can you fly with titanium plate in skull?

Yes, it is generally safe to fly with a titanium plate in your skull. The titanium used in medical implants is biocompatible and should not cause any issues during air travel. However, it is recommended to inform the security personnel about the presence of the implant before going through airport security screening.


What should I do if I have rusted license plate screws on my vehicle?

To remove rusted license plate screws on your vehicle, you can try using penetrating oil or a rust remover to loosen them. Use a screwdriver or drill to carefully remove the screws, and replace them with new ones to secure your license plate.


How do you remove the Nissan Murano license plate screws?

To remove the license plate screws from a Nissan Murano, you typically need a flathead or Phillips screwdriver, depending on the screw type. Start by locating the screws holding the license plate in place, then use the screwdriver to turn them counterclockwise until they are completely removed. Once the screws are out, carefully take off the license plate from the bracket. If the screws are rusted or stuck, applying a penetrating oil may help loosen them.


How do you change the license plate light on a Chevy Malibu?

in back above liscense plate,there should be 2 screws undo these screws, and pull out assembly to change bulb.


Is titanium used for bullet proof shield?

yes in some cases. the A-10 pilot sits inside a titanium armor plate "bathtub" while flying.


How do you change license plate in 2002 corvette?

how incomptent are you not to see the 2 screws holding the plate on????????????????


What are the symptoms of rejection of titanium plate in the cervical vertebrae?

There are a few symptoms you need to look out for when worried if your body is rejecting a titanium plate. The most common side effects are low grade fever, pain, swelling at the site of the procedure, and vomiting.


How do you get the plate off the fuel tank to change the fuel pump on a 2001 Sportage?

If it is mounted with screws then just remove the screws. If it is a locking ring, then the ring must be turned to remove than pump. The plate has screws and a retaining ring.