There should be a port at the end of the catheter where the tubing attaches to the catheter bag. Wipe with alcohol and, with a needle and syringe, insert the needle into the port and withdraw 10cc-20cc or so. Without a needle, you can take it from the bag itself, but the sample won't be as pure. You can also disconnect the catheter from the tubing and extract a sample, but this increases infection risk. If so, get a sterile container, wipe the entire area where the catheter meets the tubing with alcohol, put the catheter into the container, and hopefully you'll get about 5cc-10cc. When you reconnect, be very careful not to touch the inside of the catheter. This line runs straight into the person's bladder, and thus is a risk for bladder infection.
collected at a specific time and is tested for of glucose and acetone
A "cath spec" is a catheterized urine specimen. Most urine specimens are voided specimens when the patient attempt to collect the urine while voiding. The risk of contaminating a voided specimen, with skin bacteria, is high even when the patient is careful. Therefore, a catheterized urine specimen is considered a reliable urine sample.
Collecting a urine specimen from a urine drainage bag is acceptable when it is necessary to obtain a sample for laboratory analysis, and no other options are available, such as a clean catch. However, it should be done with caution to avoid contamination, and the specimen should be collected from the sampling port rather than the bag itself. It is important to ensure the sample is fresh and representative of the patient’s urine output. In general practice, obtaining a sample directly from the patient is preferred when possible.
To collect a specimen for a Bence Jones protein test, a 24-hour urine collection is usually required. You will be provided with a container to collect all urine passed during a 24-hour period, starting with an empty bladder and ending with a final collection at the same time the following day. The urine specimen is then sent to a lab for analysis to measure the presence of Bence Jones proteins.
To collect a 24-hour urine specimen, start by discarding the first morning urine and then collect all urine over the next 24 hours in a clean container kept on ice or in a refrigerator. Make sure to record the start and end times of the collection period and store the specimen properly to maintain its integrity for testing.
To collect a urine specimen from an indwelling catheter, first ensure proper hand hygiene and gather necessary supplies. Use a sterile syringe to aspirate urine from the catheter port, avoiding contamination. Transfer the specimen to a sterile container and label it with patient information before sending it to the lab for analysis.
Random urine sample First morning urine sample Midstream clean-catch urine sample 24-hour urine collection Timed urine sample Postprandial urine sample Suprapubic aspiration specimen Catheterized urine specimen Pediatric urine bag specimen
Typically midstream urine is taken as a urinary specimen, when you have urinary tract infection. It is good precaution to scrub the genital area with some mild soap like glycerin soap, before you take the urine specimen.
A random urine specimen is a urine sample collected at any time without following a specific time schedule or fasting requirement. This type of specimen is commonly used for routine screenings or as a general sample to check for various medical conditions.
yes, example of urine culture and sensitivity.
Regular Insulin.
Using a standardized Urinalysis System