To read 150 mg on a 3 ml syringe, you first need to know the concentration of the solution you're measuring. If the concentration is provided (e.g., mg/ml), you can calculate the volume needed for 150 mg. For example, if the concentration is 50 mg/ml, you would draw 3 ml to get 150 mg. Always ensure to check the syringe markings carefully for accuracy.
To measure 0.3ml in a 1.875ml syringe, you would fill the syringe up to the 0.3ml mark. This is typically the third smallest mark on the syringe. Make sure to read the measurements carefully to ensure accurate dosing.
0.3 ml in a 1.875 ml syringe is equal to 16% of the syringe's capacity.
3ml syringe
Where is 0.9ml on the 3ml syringe?
This is a badly phrased question. 3 cc = 3ml. a millilitre is a centimetre cubed and that is exactly what cc means. if the syringe takes a max of 3ml, then 3.125 is a full syringe and a 1/24th of a syringe
0.9 ml on a 3 ml syringe is slightly less than one-third of the total capacity of the syringe. It is marked between the 0.8 ml and 1.0 ml graduations on the syringe. This measurement is crucial for precise dosing in medical or laboratory settings. Always ensure to read the syringe at eye level for accuracy.
On a 3ml syringe, 0.125ml is located between the 0ml and 0.2ml markings. Since the syringe is typically marked in increments of 0.1ml, you would estimate the 0.125ml mark as halfway between the 0.1ml and 0.2ml lines. It is important to ensure accuracy when measuring small volumes like this.
On a 3ml syringe, 0.4ml would be indicated slightly less than one-third of the total syringe volume. You can estimate this by observing the markings on the syringe, as each milliliter is typically divided into smaller increments. Specifically, 0.4ml would be four-tenths of the way up from the 0ml mark, closer to the 0.5ml mark but not reaching it.
It is much easier to just use a insulin syringe and withdraw to .21/2 or .2 and 5 small lines
Normally when working with injection medications, always go with the smallest syringe. If asked to withdraw 0.3 mL then use a 1mL syringe. If that isn't doable, then use the 3mL syringe. If asked to draw 4mL, use the 5 and so on. As far as a vein graft however, I believe a 3mL syringe will create higher peak pressure and velocity than that of a 10 or 20 mL syringe.
On a 3ml syringe, 0.75 ml is typically located between the 0.5 ml and 1.0 ml markings. Most 3ml syringes have a series of markings indicating milliliters, with each milliliter divided into smaller increments, often 0.1 ml. Therefore, 0.75 ml would be three-quarters of the way between 0.5 ml and 1.0 ml.
only use a insulin syringe for insulin. insulin MUST be correct.