answersLogoWhite

0

It will fog up and thunder then oxygen run out and everyone will die

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

End fire antenna?

end-fire antenna = surface-wave antenna


Block diagram of microwave communication link?

A microwave communication link typically consists of a transmitter, a receiver, and an antenna at both ends. The transmitter converts the electrical signal into microwave signals, which are then transmitted through the antenna. The receiver at the other end captures these microwave signals through its antenna and converts them back into electrical signals for further processing. The link may also include devices such as amplifiers, filters, and antennas to enhance signal quality and transmission.


Is end fire array antenna non resonant antenna?

yes


Can an antenna be put on a Bose Wave Radio?

Yes. In fact, Bose offers its own "add-on" antennas for about $10 each that plug into the back of their radios. These are simple dipoles -- T-shaped wire, with the arms about 2 feet long and a longer center wire with a connector on the end. Similar antennas are available from other vendors too. Be aware that depending on when you bought the Wave radio, it may have either a standard F connector or a 1/8 inch minijack on the back for antenna connections -- make sure you get the right one. And yes, you can plug a more sophisticated indoor or outdoor antenna into the same jack. With any antenna, its effectiveness depends on where you locate it. An outdoor antenna has to be pointed in the general direction of the radio station(s) you're trying to receive for best performance. Indoor antennas are highly affected by location and position. You'll have to move them around to find the best location. With a little experimentation you should get a much stronger, cleaner signal than the built-in antenna provides.


Why test antenna in receiving mode?

If you run the antenna under test in the receiving mode, then while it is rotated, you'll monitor signals received by the antenna under test. If you run the antenna under test in the transmit mode, then while you rotate it, you'll monitor signals received by a different antenna on the test range. Either way, the varying signal must be monitored at the receiving end of the link. It's a lot more convenient, and a simpler configuration, to have the signal monitor and the rotation/excitation controls for the antenna under test in the same place, in order to react appropriately to any funny things noted during the test run.


Does outdoor have a suffix?

No, outdoor does not have suffix. Nothing was added to the end of the word.


When did The Outdoor Room end?

The Outdoor Room ended on 2008-11-30.


When did Bureau of Outdoor Recreation end?

Bureau of Outdoor Recreation ended in 1977.


When did General Signal end?

General Signal ended in 1998.


How many bell strikes to signal end of watch?

8 bell strikes signal end of watch


Why collision detection is not possible in wireless network?

two reasons 1. In wireless each station has one antenna for both sending and receiving. hence we cant use the same antenna for both transmitting and at the same time detecting collisions. Further even if we have two antennas, it will be difficult to detect collision. because the transmitting signal power will be much higher than the incoming signal. hence if the sender senses signals it will fairly get a net result (an addition) of its transmitted signal and any other signal transmitted by others. it may be that its own signal is so much powerful than others that it will not recognize any collision. 2. In wireless, only the receiver is in problem. not the transmitter. so detecting for collisions at the senders end does not really make sense. we need to detect collision at the receivers end. the sender is not able to tell it whether there is a collision in receivers end. sukarna_barua@yahoo.com


What is the plural form of wireless antenna and it does not end with an s?

wireless antennae