The car beeps to let you know your door is open so you don't drive away while your door is open or ajar
Check your contacts on the inside of the door opening. The ones on the door look like thick pins and they make contact with metal cylanders on the crossbeam. If they don't make a good connection, you can get that error. Use either rubbing alcohol or an pencil eraser to clean the flat cylanders and your problem will be solved.
Uncle Sam
Ribbons on the door symbolizes the death of a loved one.
The Door That Has No Key was created on 1921-02-22.
why did the mohawksrefer to themselves as the keepers or the eastern door.
get a manual
Per Crutchfield 6 by 8 in the front and 6 1/2 in the back door. Hope this helps
Hi! The fuel doors are not the same size.
Look in your owner's manual and on the driver's door post.
it should be on the left side of the dash when you open the door
195 55 r15 you can also check the labelling on the drivers door for this info
For the front speakers, take apart the door, disconnect the speaker wires and unscrew support screws.
Yes, of course your Mazda dealer can get you one, but for a ransom (close to $60), and apparently no after market parts house or discount parts store has'em. In addition, the door handle should not have broken in the first place, so it would be nice if the Mazda part was a stronger one, but it isn't, it is the original part (which may break just as well). Not too cool.
We have a 2002 Protege so I assume it is similar to yours. 1) Carefully remove the Door Panel 2) Unscrew and remove the Door Lock mechanism 3) Now simply separate the Door Lock Actuator from the Door Lock (The Door Lock Actuator is the part with the wires coming out of it.) Installation is the reverse. Have Fun!
remove door panel, remove speeker.
If you're looking to replace the interior door handle for a Mazda Protege, it's important to ensure you have the correct model year, as designs may vary. You can find replacement handles at automotive parts stores, online retailers, or through a Mazda dealership. Installation typically involves removing the door panel to access the handle mechanism, which can often be done with basic tools. Always consult your vehicle’s service manual for specific instructions and compatibility.
To remove the rear door handle on a 2002 Mazda Protege, first, ensure the door is open and then remove the interior door panel by unscrewing any visible screws and gently prying it off with a trim tool. Next, locate the handle's mounting screws, usually found inside the door cavity, and remove them. Disconnect any linkage or wiring attached to the handle, then carefully pull the handle out from the exterior side of the door. Reassemble in reverse order after replacing or repairing as needed.