What are the steps to properly install a rear quick release skewer on a bicycle?

Answer 1

To properly install a rear quick release skewer on a bicycle, follow these steps:

1. Insert the skewer through the hub axle, making sure the springs are on the outside of the dropouts.
2. Thread the nut onto the skewer on the non-lever side, but do not tighten it fully.
3. Close the lever on the opposite side and make sure it is in the closed position.
4. Tighten the nut on the non-lever side until it is snug, but not overly tight.
5. Close the lever with enough force to secure the wheel in place, but not too tight that it is difficult to open.
6. Check that the wheel is centered and secure before riding.