The slope would be zero.In contrast, the slope of a vertical line would be infinite.
I do not believe the fat PS3 was designed to be placed in a vertical position like the lower power and lower heat of the PS3 slim. That is why the slim was the first to have the Sony Produced stand available
The word vertical refers to something that is standing in an upright position.
Vertical means up and down. A horizontal line goes from the left to the right (or from the right to the left) like this: ----------------------------- A horizontal line goes from a position that is low to a position that is high (or from a position that is high to a position that is low) like this: | | | | | | | | But the word "vertical" does not tell you which direction the line is drawn, just the it is a line.
Horizontial or vertical, depending on where you cut it.
Vertical
gravity determines waters position
hehehe
you can do vertical graphs or data's it can be both ways
The antenna of walky talkies are vertical when in position, so to better pick up radio waves more accurately.
power, prestige, and position
Fig. 11 Valve Timing MarksRemove engine front cover as outlined previously.Remove crankshaft oil slinger.Crank engine until timing marks on sprockets are in alignment, Fig. 11.Remove three camshaft to sprocket bolts.Remove camshaft sprocket and timing chain together. Sprocket is a light press fit on camshaft for approximately 1/8 inch. If sprocket does not come off easily, a light blow with a plastic hammer on the lower edge of the sprocket should dislodge it.If crankshaft sprocket is to be replaced, remove it with a suitable gear puller. Install new sprocket, aligning key and keyway.Install chain on camshaft sprocket. Hold sprocket vertical with chain hanging below and shift around to align the timing marks on sprockets.Align dowel in camshaft with dowel hole in sprocket and install sprocket on camshaft. Do not attempt to drive sprocket on camshaft as welch plug at rear of engine can be dislodged.Draw sprocket onto camshaft, using the three mounting bolts. Tighten to specifications.Lubricate timing chain with engine oil and install cover.