No, a 12/2 wire is typically rated for a maximum of 20 amps.
10 Guage Wire Will Handle 30 Amps. Most ovens require 50A, so no.
No such circuit exists.
A 10 gauge wire can handle a maximum amperage of around 30 to 40 amps, depending on the specific type of wire and the conditions it is used in.
Yes, if the voltage is 120V, then 30 amps can handle 3600 watts. If the voltage is 240V, then 30 amps can handle 7200 watts.
A 10-gauge wire can typically handle around 30-35 amps of current. It is important to consult the National Electric Code and wire manufacturer specifications to determine the maximum current carrying capacity of a specific wire in a given installation.
For a 12VDC system with 30 amps, you would typically use a wire size of at least 8 AWG (American Wire Gauge) to ensure it can handle the current without overheating. It's always a good idea to consult a wire ampacity chart to select the appropriate wire size based on the length of the wire run and the specific conditions of your setup.
Typically 30 amps.
A wire is not like a bucket that holds amps but more like a pipe that lets the amperage flow through it. A # 14 wire is rated at 15 amps. Code only allows up to 80% for continuous use, 15 x .8 = 12 amps.
Yes, a #10 wire will carry 30 amps for 30 feet. If the load is rated as continuous then the wire will have to be derated to 80% capacity which will leave you with 24 workable amps. If the load demands currents higher that 24 amps then you will have to go to the next wire size up which is a #8 which is rated at 45 amps.
The appropriate wire size for a circuit that requires 30 amps of current is typically 10-gauge wire.
12awg will handle about 20 amps, so 10awg should handle 25-30 amps. Keep in mind that length plays a role in wire size selection. In house wiring, a wire run of 50 ft will work for 15 amps at 14awg, but increase the length to 100ft and you should use 12awg to carry 15 amps correctly.
Look on the heater and see what amps it is pulling. That will determine the wire size and breaker size. It must be on a dedicated circuit. 15 amps = AWG # 14 wire with 15 amp breaker 20 amps = AWG # 12 wire with 20 amp breaker 30 amps = AWG # 10 wire with 30 amp breaker 40 amps = AWG # 8 wire with 40 amp breaker