To convert a regular outlet into a half switched outlet, you will need to rewire the outlet so that one half is controlled by a switch while the other half remains always on. This involves identifying the hot and neutral wires, disconnecting the tab connecting the two outlets, and connecting the switched wire to one outlet and the always-on wire to the other. It is recommended to consult a licensed electrician for this task to ensure safety and compliance with electrical codes.
A half hot outlet is an electrical outlet where one half is always powered and the other half can be controlled by a switch. To install a half hot outlet in a residential setting, you would need to first identify the outlet you want to convert, then rewire it so that one half is always on and the other half is controlled by a switch. This can be done by connecting the switched wire to the outlet's hot terminal and the always-on wire to the outlet's neutral terminal. It's important to follow proper safety precautions and consult a professional electrician if needed.
This answer will be treated cautiously because your question shows a lack of knowledge of residential electrical systems. By "two prong", you are probably referring to a duplex electrical outlet, the standard "two-plug" arrangement found in North American homes, which is actually a 6-prong outlet - a live, neutral and ground "prong" on each of the two outlets. In any case, yes you can change one half of the outlet to "switched' without changing the other half. There is a connecting copper buss on each side of the duplex that connects the top half with the bottom half. This is designed in such a way that the buss can be clipped with electrical wire cutters (after ensuring that you have turned off the breaker or pulled the fuse to that circuit) to separate the two halves. You need only clip the "live" side, and can leave the neutral side connected. This will essentially allow you to feed each half with a separate supply, one of which can be live all the time, while the other half is switched. To wire up the switch, you will probably need a bit more knowledge.
turn off circuits one at a time until one of the outlets you are concerned about goes off, and leave it off now check the OTHER outlets you are concerned about if any of the OTHER outlets are still alive, then they are on a different circuit
To properly wire a half hot outlet in your electrical system, you will need to connect the hot wire to the brass terminal, the neutral wire to the silver terminal, and the switched hot wire to the other brass terminal. Make sure to turn off the power before starting and follow all safety precautions. It is recommended to consult a professional electrician if you are unsure.
Most switched outlets have one half that's hot all the time. If that's the case it will be as easy as changeing the outlet. In the center of each side of the outlet there is a small piece of copper connecting the two screws. Look and see if the copper piece is broken on the hot side, if it is then replace the outlet using the constant hot. Cap off the unused wire from the switch. If both sides of the outlet are switched then you can remove the two wires from the switch and tie them together. then either replace the switch and have a dummy or put on a blank cover. You should be all set.
To convert milk into half and half, you can mix equal parts of whole milk and heavy cream. This will create a mixture with a fat content that is similar to commercial half and half.
The answer depends on what you want to convert them to!
To convert half and half to milk for a recipe, you can mix equal parts of whole milk and heavy cream. This will give you a similar consistency and fat content to half and half.
To convert half and half to whole milk, mix equal parts of half and half with water. This will dilute the fat content and create a mixture similar to whole milk.
take half of it take half of it
There are 16 half pints in a gallon
It is half the size of a regular Trumpet.