0
What else can I help you with?
Why is it a problem if the toilet flange is too high?
If the toilet flange is too high, it can cause the toilet to not sit properly on the floor, leading to leaks, instability, and potential damage to the flooring.
Is it possible to install a toilet properly if the toilet flange is too high?
Yes, it is possible to install a toilet properly even if the toilet flange is too high by using a flange extender or a wax ring with an extra-thick flange. These solutions can help ensure a secure and leak-free installation of the toilet.
Why is the water level in the toilet bowl too low?
The water level in the toilet bowl may be too low due to a clog in the toilet's trap, a problem with the fill valve, or a leak in the tank.
Why is the water level too low in the toilet bowl?
The water level in the toilet bowl may be too low due to a clog in the toilet's trap, a problem with the fill valve, or a leak in the tank.
What to do when toilet flange is too low?
Fix it! duh!Try Double deep deal wax gaskets and longer floor flange bolts Would be the correct answer ..Always ask to see the masters license as not all plumbers can pass these exams
Why is the toilet water level too low?
The toilet water level may be too low due to a clog in the pipes, a faulty fill valve, or a problem with the flapper valve. It is important to check these components to determine the cause of the low water level.
You are working with a 3 inch PVC drain pipe and a 3 inch PVC flange and there is too much play as you insert the flange into the drain pipe?
Probably the wrong size flange. Is the flange a toilet collar? If so the pipe is probably 4 inch.
Why is the toilet bowl water level too low?
The toilet bowl water level may be too low due to a clog in the water supply line, a malfunctioning fill valve, or a problem with the float mechanism. It is important to check these components to determine the cause of the low water level and address it accordingly.
How hard is it to turn a set toilet 90 degrees to face a different direction?
It depends on the flange used and how hard it is to move the supply line. Without looking at the job it is impossible to tell. Some toilet flanges have a second mounting point 90 degrees apart, others can have the screws taken out and the mounting ring can then be turned 90 degrees, some have no provision for movement. You would have to remove the toilet to see what you have. If the flange cannot turn or it is in too bad condition (rusted out) you will have to replace it or use a flange repair ring. it depends on the circumstances. If there is room to put an extention flange on it would be easy. if not it depends on your pipe size running to the toilet, if the bottom of the flange is accessable or many other factors.
In an older house if you have the metal pipe for the toilet without a flange in the basement can you split the pipe and add the flange to use it for a sink drain too?
Install a ty fitting on the stack in the basement then run it to the sink. Put it low enough to account for a fall in the pipe, to allow proper drainage. Be sure to install a waste and vent pipe to code for both fixtures.
Why does my toilet not flush and instead just fill with water?
Your toilet may not be flushing properly because there could be a clog in the pipes, a problem with the flushing mechanism, or the water level in the tank may be too low. It's important to check these issues to determine the cause of the problem and fix it accordingly.
Is the water level in the toilet bowl too low?
To determine if the water level in the toilet bowl is too low, check if the water level is below the designated fill line marked inside the bowl. If it is below this line, the water level may be too low. Adjust the water level by adjusting the float in the toilet tank to increase the water level in the bowl.
