answersLogoWhite

0

Using a cable that is not approved for a specific application, like using SER cable where it is not allowed, can lead to serious consequences. It may result in electrical hazards, fires, damage to equipment, and even injury or loss of life. It is important to always use the correct cables for their intended purpose to ensure safety and prevent potential risks.

User Avatar

AnswerBot

7mo ago

What else can I help you with?

Related Questions

Is non-metallic sheathed cable permitted in Los Angeles County?

Yes, non-metallic sheathed cable (commonly known as NM cable or Romex) is permitted in Los Angeles County for residential wiring applications. However, it must be installed according to the California Electrical Code and local amendments. Additionally, specific requirements may apply based on the building type and location, so it's important to consult the local building department for compliance.


Is stacking of cables in cable tray permitted?

See NEC Article 392. It depends on the voltage, conductor size and the type of cable tray selected.


Is nonmetallic sheathed cable permitted in your area for resident wiring?

Yes, nonmetallic sheathed cable is commonly permitted in residential wiring for power and lighting circuits in most areas. However, it is important to check with local building codes and regulations, as requirements can vary by location.


What is the miximun distance permitted beteween straps on a cable installation?

Straps should be installed on the cable at distances not greater than 4 1/2 feet apart


What radius can Type ACT armored Cable be bent?

Type ACT armored cable should generally be bent with a minimum radius of 8 times the overall diameter of the cable. This ensures that the cable maintains its integrity and performance without risking damage to the armor or internal conductors. Always refer to the manufacturer's specifications for precise bending requirements specific to the cable type and application.


Why it is important to correctly rate and select a cable for the application?

Unknown


What is redundant fiber optic cable?

fiber loop application


Which size cable use for 37 kw induction motor?

For a 37 kW induction motor, a cable size of approximately 10 AWG (American Wire Gauge) would be suitable for typical installations. However, the specific cable size required would depend on factors such as the length of the cable run, ambient temperature, and voltage drop considerations. It is recommended to consult with a qualified electrician to determine the appropriate cable size for your specific application.


What are some application of shielded copper cable?

A very common application is the health care field. Shielded copper cable is often used in health care facilities for its efficiency and resistance to flame.


which wire is best for house wiringElson House is India’s largest Electric House Cable Manufacturers in Delhi, with a broad range of application-specific wires, instrument wires, and power wires.  ?

zxc


Explanation of application of the Communications cable?

common explanation of trailing power cables


What is the acceptable ohms of a cable when tested?

The acceptable ohms of a cable when tested depend on the type of cable and its intended use. For most low-voltage applications, a resistance of less than 5 ohms is typically considered acceptable to ensure efficient performance. However, for specific applications like telecommunications or power distribution, the acceptable resistance may vary and should be referenced against industry standards or manufacturer specifications. Always consult relevant guidelines for the specific cable type and application.