For electrical wiring in a house, typically 12 or 14 gauge wire is used. The specific gauge depends on the electrical load and circuit requirements.
For a house, it is recommended to use 12-gauge wiring for general electrical circuits. This gauge is suitable for most household appliances and lighting fixtures.
The electrical inspector will make this decision as to what circuits should be replaced.
domestic electrical wiring designig
Mixing different gauge wires in the same circuit is not recommended as it can lead to electrical hazards. It is better to use the same gauge wire throughout the circuit to maintain consistency in the electrical load. If you're adding new lights and outlets, it's best to use the same gauge wire as the existing one.
The lights flicker in the house due to fluctuations in the electrical current, which can be caused by issues with the power supply, wiring, or electrical appliances.
The term 'house earthing' is used in the electrical wiring of a structure in order to ground the house against electrical leakage which can cause increased power usage and the possibilty of safety concerns involving electrical shock.
Red or Blue
The lights are blinking in the house because there may be an issue with the electrical wiring or a problem with the light bulbs.
Electrical conductors are measured in gauge (AWG). There is not in gauge common in a house, as several are used to conduct various currents. Common gauges would be 14awg, 12awg, 10awg 8awg and 6awg. 14 and 12 being the bulk of wiring for switches and outlets. Larger sizes for higher current (amps) loads like electric stoves, dryers and air conditioning. Note : The gauge (AWG) moves from the larger number as the smaller gauge to the smaller number as the larger, that is 14 is smaller than 12 and 12 is smaller than 10 etc....
Both parallel and series circuit are used in the wiring of a house.
Concealed wiring is wiring that can not be seen. A good example of this is house wiring that is located behind the wall board. The word concealed gets mentioned in the electrical code. It states, that any concealed wiring cannot be covered until the electrical inspector or one of his representatives checks to make sure that the installation is safe to cover.
Usually electrical engineers do not get involved with house wiring. The responsibility lies with the electrician knowing the code rules and his work getting passed by the electrical inspector.Answer">AnswerAn electrical engineer is likely to be involved with the design of residential wiring systems, but not the installation -which must be performed by a qualified electrician. Electrical engineers, generally, do not have the necessary skill of hand training and certification required to perform wiring installations. In other words, while electrical engineers have higher academic qualifications, they do not have the skill-set requirements that electricians possess.