answersLogoWhite

0

The purpose of a snap switch in an electrical circuit is to control the flow of electricity by opening or closing the circuit when activated.

User Avatar

AnswerBot

8mo ago

What else can I help you with?

Related Questions

How does one play Snap Circuit?

One plays snap circuit by electric system which allows one to build electronic circuits and devices. This game comes with Elenco Electronics snap circuits SC-300.


What does a battery snap do?

A battery snap in electronics is what you connect a battery to. The battery snap then sends the electricity in the battery to the rest of the circuit. It's that simple.


Micro switches are used for what purpose?

Micro switches are small snap-action switches generally used in some type of electronic circuit for some type of repetitive motion. In an air conditioning unit, a micro switch might send a signal to turn the compressor on or off when a room reaches a certain temperature.


How do you turn it on there is no switch?

You can either clap or snap. ----


Can you bend a circuit board?

no you cannot if you try to bend it it will snap


Snap circuit whistle chip?

I dont know what the anwer is


In Pokemon Snap how do you get the mankey on the switch after you got the squritle to hit it?

i think you have to hit it with another apple or lure it on the switch with a apple


What does a battery snap do in a circuit?

A battery snap is a kind of connector, used on certain batteries. Popular 9v batteries have terminals on them like a 'press stud'. They are polarized, one connection is like a claw and the other like a button. This make sure that the connection only fits one way round or on the correct terminals, preventing reverse polarity damage. Small batteries like the PP3, have the two connectors on one clip, or board. Larger batteries will have the connectors separate, one on each wire.


What is a battery snap used for?

The function of a battery snap is to stop the current from the battery from flowing whenever you want to, and so that its safer.


How do you wire an AFCI breaker?

To wire an AFCI breaker, first turn off the power to the circuit. Then, connect the hot wire to the breaker's terminal, the neutral wire to the neutral bar, and the ground wire to the ground bar. Finally, snap the breaker into place in the electrical panel.


Do gas valves snap open and closed?

Purpose of the servo pressure regulator system


Where can one get a replacement video circuit for an electronics kit?

One can get a replacement video circuit for an electronics kit from the these stores: Element 14, Maplin, Snap Circuits, Makey Makey, Circuit Medic, Electronic Kits, Solder.

Trending Questions
How can I install vinyl flooring on stairs with nosing? What are some tips for finding a cheap nail gun without compromising on quality? What are the differences between wire nuts and Wago connectors in terms of their effectiveness and ease of use for electrical connections? How can I fix a leaky outdoor frost-free faucet? What are the differences between open cell and closed cell spray foam insulation? How to sand a ceiling properly for a smooth finish? How can I fix a flapper for a toilet that is not sealing properly? How can I achieve smooth round edges on wood when cutting? What are the benefits of installing under cupboard lighting in a kitchen? How to tell the swing of a door? What is the difference between the RH and RC terminals on a thermostat? What are the best features to consider when choosing an outdoor plug box for your outdoor electrical needs? What is the purpose of a tandem 20 amp breaker and how is it different from a standard single-pole breaker? How can I properly install a doorbell transformer? How does a sink instant hot water system work and what are the benefits of having one installed in your home? Do you have to seal granite countertops for maintenance? What are the benefits of using fast drying joint compound for a home renovation project? How can I create DIY concrete pavers for my outdoor space? What are the benefits of using an oil radiator for heating in comparison to other heating methods? How can I effectively hide wires behind a wall?