0
What else can I help you with?
What size service cable for 100 amp main panel 100 feet away?
For a 100 amp main panel located 100 feet away, it is recommended to use a 2/0 copper or 4/0 aluminum service cable to ensure proper voltage drop and capacity for the distance. Consult with a licensed electrician to determine the specific requirements based on local codes and conditions.
What size wire do you need for a amp sub panel A feet away?
To determine the appropriate wire size for an amp sub panel located a certain distance away, you need to consider the total load (in amps) and the distance (in feet). Generally, for a 100 amp sub panel, a minimum of 3 AWG copper wire is recommended for runs up to 100 feet, while 1 AWG copper may be necessary for longer distances to account for voltage drop. Always consult local electrical codes and, if unsure, consider hiring a licensed electrician for accurate specifications and safety.
What is the recommended height for installing an electric panel in a residential building?
The recommended height for installing an electric panel in a residential building is typically around 5 feet from the floor to the center of the panel. This height allows for easy access and operation of the panel while standing.
Where is the EEC located on a 1994 bronco?
Most computors are located behind the passenger side kick panel. That's the panel to the right of your feet while sitting in the pass seat.
Where is the lighter fuse located in a 92 Saturn?
The fuse is located under the radio in the right side there is a panel ( by the passengers feet) Pull off that panel the fuse is in that "block" you see The fuse identification is printed on the inside of the panel
What gauge wire to use for direct burial for a garage that is 400 feet from your house?
Depends on the size of the sub-panel in that garage. If you are installing a 60 amp sub-panel 400 feet away from the main service panel then use AWG # 4.
Where is the kick panel located on 1998 ford explore?
The kick panel is the interior plastic trim panel ahead of the front doors on the passenger and driver side next to the persons feet
What is the recommended installation procedure for ground rods for a sub panel?
The recommended installation procedure for ground rods for a sub panel involves driving the rods into the ground near the sub panel location, ensuring they are at least 8 feet apart, and connecting them to the sub panel with copper wire. This helps to provide a safe path for electrical currents to dissipate into the ground.
Where is fuse box located on 2005 ford expedition?
On a 2005 Ford Expedition : The fuse panel / power distribution box is located in the front passenger footwell behind the swing out kick panel * the kick panel is the interior trim panel , just in front of the front door , beside the persons feet
Where is the 4x4 contol module located on 1999 Ranger XLT ext cab?
inside the kick panel on the passengers side , it is the panel just to the right of where you put your feet
Location of the 13-position relay panel on a 1998 VW Beetle?
The relay panel is located under the dash board, above the drivers feet, remove the lower cover panel to access relay box.
What size copper wire is need to feed a 100 amp subpanel located 6 feet from a 200 amp main panel?
For a 100 amp subpanel located 6 feet from a 200 amp main panel, you would typically use #3 AWG copper wire. This size is adequate for carrying the load while minimizing voltage drop over the short distance. It's always recommended to consult local electrical codes or a licensed electrician to ensure compliance and safety.
