0
What else can I help you with?
What has to be done in order for electrical appliances to work?
For electrical appliances to work the wires must be correctly connected and plugged in to the receptacle.
Why do you use conducting wires to cover electrical cords attached to household appliances?
I believe you've managed to turn wires inside out. (conducting) wires are covered in insulating plastic. And it is done this way to prevent electrical energy from going where it is not wanted, such as into you.
What should be done with unused pins of gates?
depends upon the type of gate.eg: in case of an AND you must connect it to high while in case of OR,one must ground the unused pins...
How do you replace up-light bulbs on a ceiling fan as they are surrounded by wires?
The bulbs should never be surrounded by wires. It sounds like some modifications have been done to that fixture. Up lights means that the bulb shell is below the bulb. this is where the wires should be terminated. To be on the safe side get an electrician to look at it and get his opinion as to what to do and get it rewired properly. Don't take chances with modified electrical equipment.
What safety precautions apply to trailing power leads?
For safety precautions trailing power leads should be individually capped off. This can be done using a plastic tape designed especially for electrical wires or a permanent plastic cap.
What should be done if an ammeter reacts in a reverse direction?
Swap the two wires connected to the Ammeter
What should be done with any used it unused chemical once it has been taken from the original container?
An unused portion of a chemical taken out of its container should be properly disposed of. The original container has identification information and warnings. Chemical that been poured out may become contaminated so should not be poured back.
What should be done with any unused or used chemical once it has been taken from the original container?
An unused portion of a chemical taken out of its container should be properly disposed of. The original container has identification information and warnings. Chemical that been poured out may become contaminated so should not be poured back.
What should be done with unused TTL output?
Unused TTL inputs should never be left open. Depending on how their logic levels will affect the operation you want from the device, unused inputs should always be tied to either the +5v supply (logic 1) or to the circuit ground (logic 0). If an input is left open ("floating"), then it can assume either logic level, and you literally never know which state it's in.
How can I add ground wires to old outlets?
To add ground wires to old outlets, you can hire a licensed electrician to install a ground wire or use a ground fault circuit interrupter (GFCI) outlet as an alternative method. It is important to ensure that the wiring is done safely and in compliance with electrical codes to prevent electrical hazards.
What should be done onboard a vessel during a lightning storm?
Unplug all electrical equipment
How can I safely move an electrical outlet to a different location in my home?
To safely move an electrical outlet to a different location in your home, you should first turn off the power to the outlet at the circuit breaker. Then, carefully remove the outlet from the wall and disconnect the wires. Next, run new wiring to the desired location and install a new electrical box. Finally, connect the wires to the new outlet and securely mount it in place. It is recommended to consult a licensed electrician for this task to ensure it is done safely and up to code.
