If you find a sprinkler box full of water in your yard, you should first turn off the water supply to prevent further flooding. Then, contact a professional sprinkler repair service to assess and fix the issue. It is important to address the problem promptly to prevent damage to your yard and property.
The sprinkler valve box is full of water because there may be a leak in the irrigation system, causing water to accumulate in the box.
After a main water valve is closed the system's PVC pipes are still full of water and will drain to the lowest sprinkler head until the system is empty.
The boiler expansion tank should not be full of water. It should have a mix of water and air to allow for expansion and contraction of the water in the system. If the tank is full of water, it may indicate a problem with the tank or the system.
22 hypochlorite ampules should be used when re-chlorinating a full water trailer.
22 hypochlorite ampules should be used when re-chlorinating a full water trailer.
"The average sprinkler will use in excess of 240 gallons of water per hour" also refer to http://www.libertylake.org/water_conservation.htm for watering guide. As a useful gauge: A garden hose with no nozzle attached, will spew out as much as 350 gallons per hour. So 240 sounds about right for a sprinkler system, keeping in mind that it will vary with your local water pressure and type of sprinkler system that you have. If your system has a damaged sprinkler head, you might as well be running that garden hose full blast. My sprinkler system uses 1,000 gallons in a three hour time cycle. I have six or seven zones. I suspect some of my heads are busted, since that sounds about like "garden hose figures." (333 gallons per hour)
Drink n find out?
go to a none full grown plant then you should be able to water it.
You don't put water in your radiator, you put antifreeze.
High water pressure from the street or well, but there's an exception: City water pressure (from the street) may need to have the pressure reduced to the home. Some homes have pressure regulators for this purpose, some do not. The same goes for well systems that use a pressure pump (an often a pressure tank); the outlet pressure is set so that the pressure to the home doesn't go too high or too low. An exception for homes with fire sprinkler systems. There is a check valve from the main water supply that feeds the fire sprinkler system. As temperatures drop at night, the water in the fire sprinkler pipes contracts slightly and additional water from the main water line goes into the fire sprinkler system. During the day, the water in the fire sprinkler pipes heats up and expands slightly, but has no where to go because of the check valve. This action can cause a very high pressure in the fire sprinkler pipes if there isn't also a pressure relief valve in the system. Numerous older homes do not have a pressure relief valve for the fire sprinkler system and risk having a pipe or joint burst. The bottom line: if you suspect that you have high water pressure in the home, consult a local plumber or building contractor for the appropriate solution.
No, a well water pressure tank should be set at about 2/3 full to allow for proper functioning of the well pump and to ensure consistent water pressure in the system. Having the tank at the correct level helps to prevent rapid cycling of the pump and extends its lifespan.
The water level in the bottle should be about halfway full for a successful bottle flip.