For cutting through metal pipes, it is recommended to use a hole saw that is slightly larger than the diameter of the pipe. This will allow for a clean and precise cut.
A hacksaw is a tool used for cutting through metal, plastic, and other materials. It typically makes straight cuts and is commonly used for cutting pipes, rods, and small metal pieces.
no.
You should always check for pipes by hand, many pipes are PVC and will not show up on a metal detector.
The lead will leach into the water and give you lead poisoning.
Yes, metal pipes are conductors because they are materials that allow the flow of electricity through them. Metals, in general, are good conductors of electricity due to their free-flowing electrons within their structure.
PVC pipes are less expensive and easier to repair. Metal pipes are more expensive and more difficult to repair.
The drain metal pipes are usually coated and galvanized because of the hard water.
A hack saw is a hand tool used for cutting thin metals of various kinds like, metal plates, bolts, also smaller sized round bar, angle iron, tubing, etc. Although it is mainly used for cutting wood, it also cuts plastic perfectly.
Copper
I'm not familiar with rumbling in pipes, but the clanking of pipes when the heat starts up is a result of the pipes expanding because of the heat. Heat causes the metal to expand slightly, and the joints creak and clank when the heat makes its way through the pipes.
Most drain pipes are made of copper
Through pipes through pipes