Your belt may be breaking due to wear and tear, improper tension, or misalignment with the pulleys. Regular maintenance and proper installation can help prevent belt breakage.
The belt tensioner probably needs to be replaced - about $110 @ PepBoys. Check the alignment of all pulleys. If something isn't aligned properly the belt will keep breaking.
The belt tensioner is probably bad.
Reasons: Cheap Belt Too tight
Mow the grass,Mow the garden.
Your belt sander may be breaking belts due to several reasons, such as improper tension, misalignment of the belt, or using the wrong type of belt for the sander. It is important to ensure that the belt is properly installed and aligned, and that the tension is adjusted correctly to prevent breakage.
Whatever component that it drives is probably locking up.
Incorrect belt, too tight or too loose belt. Should be 1/4 inch deflection at the mid-point of the belt. Pulleys out of alignment or warped.
Incorrect type belt. A/C locked up. Belt adjusted too tight or too loose. Misalignment of the pulleys.
No. It is not an interference motor, and it should not be harmed by the belt breaking.
my l1742 dont want to go every time i put it in gear it burns the belt like the trans axcel is locked what is the problem
Replace your a/c evaporator filter under dash. Liquid refrigerant is getting back to compressor causing belt to break.
you must have a pulley that has a bad bearing i would take and spin each pulley with the belt off and see what one dose not spin freely and replace