The hot water pilot may keep going out due to a faulty thermocouple, a clogged pilot orifice, or insufficient gas flow.
Spillage
The pilot light on your hot water heater may keep going out due to issues with the thermocouple, a draft in the area, or a problem with the gas supply. It is important to have a professional inspect and repair the heater to ensure safe and reliable operation.
Spillage excessive condensate bad thermocouple draft
The pilot light on your hot water heater may keep going out due to a variety of reasons, such as a dirty or damaged pilot light assembly, a faulty thermocouple, insufficient gas supply, or a draft in the area where the water heater is located. It is important to have a professional inspect and repair the issue to ensure safe and efficient operation of your water heater.
is the lines on the thermal coupler and pilot light for a hot water heater supposed to get hot
Your hot water heater may keep going out due to issues like a faulty thermostat, sediment buildup, or a pilot light problem. To prevent this in the future, you can regularly flush your water heater to remove sediment, check and replace the thermostat if needed, and ensure the pilot light is functioning properly. Regular maintenance and inspection can help prevent future issues with your hot water heater.
There are several possible reasons why your hot water heater keeps going out. It could be due to a faulty thermostat, a buildup of sediment in the tank, a malfunctioning pilot light, or a problem with the gas supply. It is recommended to have a professional plumber inspect and repair the hot water heater to determine the exact cause of the issue.
The thermocouple is going bad. The thermocouple is the small tube that sits in the flame from the pilot light and goes back to the gas valve. They are easy to replace and cost $6 to $8. For health and safety the failing part should be replaced without delay by a competent gas engineer.
it sometimes takes around 45 minutes to have hot water
No, that is part of the function of the pilot light. To light the burner and to keep the gas valve open. The thermocouple sits in the flame of the pilot and produces a small electrical current that keep the gas valve open. When the tank cools down, the thermostat opens the valve to the burner so that it can light. When the pilot goes out, it is usually the thermocouple that is bad.
use insulation to keep the water hot for 40 minutes
There are a couple common reasons for a pilot light going out. 1. The thermocouple is weak. This is the gold rod that must see the flame in order to keep the gas valve open. it is a safety device that will not let the gas vavle open if there is no pilot. 2. The pilot is dirty and has a yellow flame. If this is the case, it will have to be cleaned. There are books on he market such as forced hot air furnace - troubleshooting and repair that show you how to repair your furnace. You can buy this at amazon.com