0
What else can I help you with?
What is yellow and brown at the same time?
A toilet that hasn't been flushed.
Why does the toilet continue running water and air after it has been flushed?
Because the flapper is stuck.
Why is the toilet bowl empty of water?
The toilet bowl is empty of water because the water has been flushed down the drain, carrying waste with it.
Has anyone ever been flushed down the toilet?
Sure thing, and they've all been awarded a Darwin Award.
Can you retrieve jewelry that has been flushed?
If you have a septic tank, or if it got stuck in the toilet, otherwise it's gone.
Was the toilet invented in 1998?
No, the modern toilet was not invented in 1998. The flushing toilet was developed in the late 16th century by Sir John Harington, and there have been earlier forms of toilets dating back to ancient civilizations.
Why is the toilet bowl empty?
The toilet bowl is empty because the water has been flushed down the drain, leaving the bowl dry until it is refilled with water for the next use.
What is the purpose of the toilet fill tube in a plumbing system?
The purpose of the toilet fill tube in a plumbing system is to refill the toilet tank with water after it has been flushed, ensuring that the tank is filled to the appropriate level for the next flush.
Why does the toilet keep flushing at all hours of the day and night when not in use?
The problem here is one of two problems, or both, depending on the installation of your toilet. One. The flushing rubber inside the toilet cystern on the bottom is now old and perishing and needs to be replaced. Two. Certain toilet cystern installations allow for the inlet over flow to flow into the pan of the toilet and not to the outside, thus causing the toilet to seem as though its constantly flushing, this also has a rubber inside of it and needs to be replaced. Check and make sure that the handle of the toilet is not sticky, it has been known that a sticky toilet handle (probably because the back nut is too tight) wont go down, therefore not allowing the flushing rubber to go back onto its seat to stop the water running into the pan.
Water pressure surges when flushing toilet?
There are a variety of possible reasons that would cause water not to go down when flushed. The most common reasons are (1) an object has been accidently (or spitefully!) flushed in a previous flush and lodged within the toilet or the drain pipe. (2) Build up has formed in the toilet line so that the normal contents plug the line temporarily. Solutions: mechanical snake. If necessary remove toilet. Prevention: (1) None known (2) Treat toilet line with microbial build-up remover product periodically.
Why does water continue to run in the drain near toilet and sink after the toilet has been flushed and has stopped refilling?
The discharge line (soil ) may be slightly back pitched so it takes longer to drain
Who invented the toilate?
Toilets have been in use for thousands of years. The modern toilet capable of flushing was invented in the 16th century by John Harington.
