If your door won't close after replacing the door hinges, it could be due to misalignment or improper installation of the new hinges. Check to ensure the hinges are properly aligned and securely attached to the door and frame. Adjust the hinges if needed to allow the door to close properly.
Try removing the center hinge. See if the door closes. If so the hinges need to be set into the jam or the door deeper. Adjust and re-install them. Check to see if your door has a bevel, is the bevel backwards? GL.
Adjust or replace hinges Sorry, there is no adjusting these style hinges, they are welded in place, you can usually make them better by replacing the pins and bushings in the hinges but if the hinge itself is wore that bad where bushings wont fix it you're looking at having a body shop weld new hinges in...
"Replacing a power door lock on a 4door pont G6
Access in rear door panel, allows you to lock/inlock rear door.
I'm not too certain what you mean by jammed. If you just mean out of aligned door, you can loosen your hinge screws and realign the door. If you just mean the door wont come out of the hinge, you can tap it out with a punch and grease the hinges. If you want more specific, please be more specific.
Close the door but first put a chemical by your do so they wont bring friends.
try to close it then never use it ...if i could keep it closed i wont open it again i think it has something to do with the mechanics in the door itself
usually the locking latch in the door is in the closed position. try holding the handle in the open position and opening the latch manually.
needs electric motor located underneath glass, behind door panel.
if your door wont close then i would look at the "eyes" but if it wont open or close check the wires take it wall unit off and make sure the wires are hooked up. I just learned a costly lesson and that you need to check the power. Are your red beams lit up? Check your trip switch. That's a $60 lesson and I hope I can save someone else a service call perhaps.
Fod product? Spray the door latch assembly liberally with WD-40, operate the door a few times then spray with a silicone spray
as like the key wont turn or the door is just stuck? if so id try a lock smith cuz it might have to be drilled out. if the door is stuck just tug it hard sometimes integra doors bend easily so they dont close right